![]() |
#29 | |
![]() ![]() Drives: 2015 Camaro ZL1 Join Date: Oct 2020
Location: Clinton Twp, Michigan
Posts: 249
|
Quote:
|
|
![]() |
![]() |
![]() |
#30 | |
![]() Drives: 17 hyper blue 2SS M6 Join Date: Mar 2018
Location: NorCal
Posts: 594
|
Quote:
Thanks for your response. I'll have to start looking for the 103 TB |
|
![]() |
![]() |
![]() |
#31 |
![]() Drives: 17 hyper blue 2SS M6 Join Date: Mar 2018
Location: NorCal
Posts: 594
|
|
![]() |
![]() |
![]() |
#32 |
![]() Drives: 17 hyper blue 2SS M6 Join Date: Mar 2018
Location: NorCal
Posts: 594
|
Alright, so I've ordered a bunch of stuff, and I'm looking for feedback. Have I ordered anything that is wrong? Missing something that I should be replacing? Here's my list
Katech 416 NA short block, fully forged, 11.5:1 compression LT4 injectors, in tank and high pressure pumps, and fuel lines ATI balancer BTR 660 dual springs/seals Katech oil pump NW 103 T/B JLT 5 inch cold air intake Katech LT1 track day camshaft I have a year old set of Johnson 2110r lifters that seem ok, but with the metal that went through the system I am thinking those should be replaced like I'm doing with the oil cooler. I already have an MSD unported manifold and 1 7/8 kooks headers and exclusively run E85. I plan on buying a new OEM clutch because I don't think I'll exceed it's capabilities I expect to make over 600whp, considering I was at 550whp with the stock bottom end. Thoughts? Suggestions? |
![]() |
![]() |
![]() |
#33 | |
![]() ![]() ![]() ![]() Drives: police interceptor Join Date: Nov 2008
Location: Austin, tx
Posts: 1,292
|
Quote:
A combination of a thin gasket and milling the heads a little will get you to 12.5:1 compression. Will be fine on pump gas, and respond well to E85. |
|
![]() |
![]() |
![]() |
#34 |
![]() Drives: 17 hyper blue 2SS M6 Join Date: Mar 2018
Location: NorCal
Posts: 594
|
I thought about this actually, decided on a slightly thinner gasket but I want to measure the piston to valve clearance before deciding on any other changes.
|
![]() |
![]() |
![]() |
#35 | |
![]() ![]() Drives: 2015 Camaro ZL1 Join Date: Oct 2020
Location: Clinton Twp, Michigan
Posts: 249
|
Quote:
Milling .006 nets roughly 1cc of volume if you want to do some rough calculations. |
|
![]() |
![]() |
![]() |
#36 |
![]() Drives: 17 hyper blue 2SS M6 Join Date: Mar 2018
Location: NorCal
Posts: 594
|
|
![]() |
![]() |
|
|
Post Reply
|
|
|