05-15-2024, 06:44 AM | #1 |
Torque specs for strut tower brace?
Got the GM Strut Tower brace as a visual accessory a few weeks ago. Recently got my car back from the tint/ppf shop and am looking to install the bar this weekend.
Does anyone happen to have the torque specs of the bolts involved with this? Any info would be great, Thanks!
__________________
2024 2SS Camaro, Riverside Blue Metallic, NPP, F55, CF5, 5ZZ, VTU, S0O, 5KP, JF5, 2nd Gen GFX
|
|
05-15-2024, 01:13 PM | #2 |
Drives: 2019 Chevrolet Camaro 2SS A10 Join Date: Jul 2019
Location: Hampton Va.
Posts: 317
|
If I remember correctly its 22 foot pounds
__________________
2019 Camaro 2SS A10/ Stainless Works 1-7/8 in headers with full 3 inch exhaust to Legend series black quad tipped mufflers, GPI ported intake, Soler performance throttle body, with RotoFab cold air intake, BMR strut tower brace powder coated Jazz blue to match my ZL1 1LE brake calipers, P1X Procharger with stage 2 intercooler, wide band with a P3 gauge, LT4 high side fuel system upgrades, a catch can, TCM unlock, engine and transmission tune.
|
05-19-2024, 06:09 PM | #3 |
|
Install the two new Front End Sheet Metal Diagonal Brace Bolts 22 Nm (16 lb ft) (2) and two Front Suspension Strut Upper
Mounting Bolts** (3) 22 Nm (16 lb ft). **NOTE: Some vehicle models may be equipped with Front Suspension Strut Upper Mounting Bolts with captured washers. These bolts should be torqued to 30Nm (22 lb ft). Instructions are from https://accessories.chevrolet.com/pr...maro&year=2018 https://ecom-dam.ext.gm.com/products...s_84125310.pdf I use this link for the service manual info repairlinkshop.com
__________________
|
|
|
Post Reply
|
|
|