03-19-2014, 09:03 AM | #1 |
Drives: 2019 ZL1 1LE Join Date: Mar 2014
Location: Georgia
Posts: 182
|
Vararam gap Question
Does this look OK or should I go for a bigger gap. If so how did you guys open it up more.
|
03-19-2014, 09:38 AM | #2 |
Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009
Location: Jefferson City, Missouri
Posts: 13,943
|
If your keyfob fits (if even slighly snug on one side) you are good to go. Just check it from time to time to make sure it isn't closing up more.
Mine stays about like that...the gap is usually just a bit bigger than the key fob.
__________________
2016 Camaro 1SS - 8-speed - NPP - Black bowties
2010 Camaro 1LT V6 (Sold. I will miss her!) |
03-19-2014, 11:06 AM | #3 | |
Drives: 2019 ZL1 1LE Join Date: Mar 2014
Location: Georgia
Posts: 182
|
Quote:
Got a pic of a key fob on yours. Mines pretty tight. Just seems like the cap is to small. So far it never moved everything is where it was when installed. Last edited by bignaz; 03-19-2014 at 04:19 PM. |
|
03-19-2014, 02:01 PM | #4 |
Drives: car Join Date: Jun 2012
Location: Location
Posts: 130
|
Mine was like that, then after I installed the Vmax Isolator it got a little larger as the angle is just a bit different.
|
03-19-2014, 09:47 PM | #5 |
Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009
Location: Jefferson City, Missouri
Posts: 13,943
|
Here is an old shot of mine
__________________
2016 Camaro 1SS - 8-speed - NPP - Black bowties
2010 Camaro 1LT V6 (Sold. I will miss her!) |
|
|
|
|