05-30-2014, 12:33 PM | #1 |
Drives: 2010 1SS Join Date: Jan 2013
Location: INDY
Posts: 271
|
Amp/Sub Wiring Question
Ok, here is my set-up. I have the JL 12W6V3-D4 and Alpine PDX-V9. The sub out is 500 RMS @ 4 ohms. How do I jump the W6 so its 4 ohms at the amp? Thanks in advance.
|
05-30-2014, 12:45 PM | #2 |
Drives: 2013 Ray Blue 2SS/RS Join Date: Feb 2014
Location: Kansas City, Mo
Posts: 31
|
I always use this tool on the rockford fosgate web site. It should be able to help you out.
http://www.rockfordfosgate.com/rftec...er_wizard.asp#
__________________
"Be so good they can't ignore you" |
05-30-2014, 01:33 PM | #3 |
Drives: 2018 1LE Join Date: Feb 2013
Location: delaware
Posts: 319
|
You can not make a d4 run 4 ohm. It going to be 8 ohm or 2 ohm
|
05-30-2014, 01:44 PM | #4 |
Drives: 2010 1SS Join Date: Jan 2013
Location: INDY
Posts: 271
|
|
05-30-2014, 01:46 PM | #5 | |
Drives: 2010 1SS Join Date: Jan 2013
Location: INDY
Posts: 271
|
Quote:
Thanks! |
|
05-30-2014, 11:01 PM | #6 |
Drives: 2018 1LE Join Date: Feb 2013
Location: delaware
Posts: 319
|
You can run the two coils if you wire it io so two ohm you amp will have put out more power. I think that amp is 2 ohm stable
|
05-30-2014, 11:03 PM | #7 |
Drives: 2018 1LE Join Date: Feb 2013
Location: delaware
Posts: 319
|
Also on the jl sub there are jump wires on the back it would be ++ - - vc1 vc2 for. 2 ohm load
|
|
|
|
|