Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > CAMARO6.com General Forums > ZL1 Discussions


AWE Tuning


Post Reply
 
Thread Tools
Old 02-22-2023, 09:15 AM   #29
WhiteMale

 
Drives: 23 ZL1 A10 Rapid Blue
Join Date: Aug 2020
Location: MO
Posts: 1,992
Quote:
Originally Posted by JSH View Post
I got 2500 out of my factory R3 tires. I didn't reduce camber much, but last summer I otherwise replaced all of GM's negative camber, castor, toe, steer ahead, and thrust angle with neutral/positive settings. The car is so much easier to drive around town and I haven't seen any wear on these Toyos.
YOu did a lot in your signature block to a ZLE and then neutered it with Toyo tires and this alignment, makes little sense.

Too, caster is not adjustable, Camber does not wear tires, toe wears tires. What you did makes no sense.
WhiteMale is offline   Reply With Quote
Old 02-22-2023, 10:22 AM   #30
JSH


 
JSH's Avatar
 
Drives: '20 ZLE
Join Date: Jun 2020
Location: Mile High
Posts: 3,565
Quote:
Originally Posted by WhiteMale View Post
YOu did a lot in your signature block to a ZLE and then neutered it with Toyo tires and this alignment, makes little sense.

Too, caster is not adjustable, Camber does not wear tires, toe wears tires. What you did makes no sense.
It makes perfect sense for a straight-ahead car. Improper camber can make the tire wear on one edge, which it did. I left some camber in it but zero camber will result in the most uniform tire wear. This Toyo makes a really good dry road and strip tire. I'll buy the Nitto 555Rii in 345 if and when it ever becomes available again.
__________________
'20 ZL1 1LE A10,
OEM short block, LME heads/valve train, E2650.
100+ octanes, no eth, no meth, no N2O.
2/23 - 1031/1004 wheel.
4/23 - 1.41/9.61/145 at DA 7000 ft. (only made five passes).
2/24 - LME 390, E2650, FBO, 100 oct.; 1116hp/ 1063tq; 109 oct. dyno next.

Last edited by JSH; 02-22-2023 at 06:21 PM.
JSH is offline   Reply With Quote
Old 02-22-2023, 10:26 AM   #31
Rayvan
Rayvan
 
Drives: 2018 1SS1LE, Silver Ice Metallic
Join Date: Dec 2018
Location: San Jose, CA
Posts: 275
Run them until they're cording. Anyone who "thinks" than their F1 tires are "shot" at only a few thousand miles can send them to me. I'll double that easy, and I track my car.

My rears corded at 14,000 miles. My fronts are still "trackable" at 16,000.

Seriously, I'll pay the shipping.
Rayvan is offline   Reply With Quote
Old 02-22-2023, 12:18 PM   #32
Vigilante375

 
Drives: 2018 Camaro ZL1
Join Date: Aug 2018
Location: Georgia
Posts: 1,370
Quote:
Originally Posted by WhiteMale View Post
YOu did a lot in your signature block to a ZLE and then neutered it with Toyo tires and this alignment, makes little sense.

Too, caster is not adjustable, Camber does not wear tires, toe wears tires. What you did makes no sense.
Camber does wear tires more on which offset you have then on which will lead to uneven wear.

One side of the tire will look brand new while the other will look like it's been on there for 100,000 miles.
Vigilante375 is offline   Reply With Quote
Old 02-22-2023, 05:34 PM   #33
Raisin Man
 
Drives: Chevrolet Camaro
Join Date: Feb 2022
Location: Florida
Posts: 54
Quote:
Originally Posted by Gunkk View Post
9700 miles and I still have 2mm of slick rubber left (dimples).

Also a fan of the OE Goodyear's. Expecting no more than 8-12K miles on a set of these tires. Longevity probably about the same vs. other manufacturers for a high performance summer tire with proper alignment. Only have about 3K miles on my 2022 ZL1, but the Goodyear's stick like a mofo. Michelin OK of course, and I have Pilot Sports on other cars, but I'll buy the Goodyears again for ZL1.
Raisin Man is offline   Reply With Quote
Old 02-22-2023, 05:58 PM   #34
LT4Greg


 
LT4Greg's Avatar
 
Drives: 2017 Camaro ZL1 Coupe
Join Date: May 2016
Location: Georgia
Posts: 5,813
I will probably get another set of Goodyear tires for my ZL1 when comes time to replace mine. That’s what the ZL1 was designed for but everyone is different.
__________________
ZL1 Coupe, PDR, Exposed carbon fiber hood insert, My Link with Nav, M6 6 speed and Silver Ice Metallic. Mods done: ceramic window tint, GM Accessories Camaro floor mats and Roto-Fab CAI.
LT4Greg is offline   Reply With Quote
Old 02-22-2023, 06:16 PM   #35
JSH


 
JSH's Avatar
 
Drives: '20 ZLE
Join Date: Jun 2020
Location: Mile High
Posts: 3,565
Quote:
Originally Posted by Rayvan View Post
Run them until they're cording. Anyone who "thinks" than their F1 tires are "shot" at only a few thousand miles can send them to me. I'll double that easy, and I track my car.

My rears corded at 14,000 miles. My fronts are still "trackable" at 16,000.

Seriously, I'll pay the shipping.
I think I've still got my 3R's. If so, do you want them?
__________________
'20 ZL1 1LE A10,
OEM short block, LME heads/valve train, E2650.
100+ octanes, no eth, no meth, no N2O.
2/23 - 1031/1004 wheel.
4/23 - 1.41/9.61/145 at DA 7000 ft. (only made five passes).
2/24 - LME 390, E2650, FBO, 100 oct.; 1116hp/ 1063tq; 109 oct. dyno next.
JSH is offline   Reply With Quote
 
Post Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:45 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.