You are browsing camaro6 
12-02-2020, 10:57 AM
|
#1 |
 Drives: Camaro ZL1 Join Date: May 2020
Location: Tampa
Posts: 166
|
brake screeching sound
Every time I brake theres this loud screeching sounds coming from them. I believe its from the right side but cant pinpoint which wheel. Anyways I got my tires replaces about a month ago and had them check the breaks. They said they were at a little bit above 50%.
Any suggestions? |
|
|
|
12-02-2020, 11:40 AM
|
#2 | |
         
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 3,560
|
Is it not under warranty? If yes, let the dealer solve it.
Quote:
__________________
'20 ZL1 1LE A10,
OEM short block, LME heads/valve train, E2650. 100+ octanes, no eth, no meth, no N2O. 2/23 - 1031/1004 wheel. 4/23 - 1.41/9.61/145 at DA 7000 ft. (only made five passes). 2/24 - LME 390, E2650, FBO, 100 oct.; 1116hp/ 1063tq; 109 oct. dyno next. |
|
|
|
|
|
12-02-2020, 11:48 AM
|
#3 | |
 
Drives: 2017 Chevrolet Camaro ZL1 M6 Join Date: Jul 2020
Location: OR
Posts: 479
|
Quote:
|
|
|
|
|
|
12-02-2020, 12:38 PM
|
#4 |
   
Drives: 2018 Camaro 2SS A8 Join Date: Jul 2017
Location: East Tennessee
Posts: 11,616
|
If it isn't the wear indicator, perhaps something got stuck between one of the pads and the rotor?
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle terminator cam | LT4 FS & injectors | TSP forged pistons & rods JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune 1100 - 1/30/18 | 2000 - 1/31/18 3000 - 2/06/18 TPW 2/26/18 3400 - 2/19/18 | 3800 - 2/26/18 4300 - 2/27/18 | 4B00 - 3/01/18 4200 - 3/05/18 | 4800 - 3/14/18 5000 - 3/16/18 | 6000 - 3/19/18 |
|
|
|
|
12-02-2020, 12:50 PM
|
#5 |
|
Drives: Camaro ZL1 Join Date: May 2020
Location: Tampa
Posts: 166
|
It was done at a tireshop (Tirechoice) not dealer. Car just hit 14,500.00 so warranty is done.
|
|
|
|
|
12-02-2020, 01:03 PM
|
#6 |
|
Account Suspended
Drives: '21 Wild Cherry ZL1 Join Date: Aug 2018
Location: WI
Posts: 2,082
|
Mine squeal from time to time.
|
|
|
|
|
12-02-2020, 01:39 PM
|
#7 |
|
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 3,560
|
Mine have never made a sound
__________________
'20 ZL1 1LE A10,
OEM short block, LME heads/valve train, E2650. 100+ octanes, no eth, no meth, no N2O. 2/23 - 1031/1004 wheel. 4/23 - 1.41/9.61/145 at DA 7000 ft. (only made five passes). 2/24 - LME 390, E2650, FBO, 100 oct.; 1116hp/ 1063tq; 109 oct. dyno next. |
|
|
|
|
12-02-2020, 02:06 PM
|
#8 |
|
Drives: 2018 Camaro ZL1 Join Date: Aug 2018
Location: Georgia
Posts: 1,370
|
Mine squeal from time to time. Have you been to any racing events?
This wouldn't been covered under warranty because brake pads are a fair and wear item. These OEM pads will squeal as the pads wear down. I'd give the brakes a good hard stop from 20 or so and the noise should go away. For a while. |
|
|
|
|
12-02-2020, 02:33 PM
|
#9 |
Drives: 2019 ZL1 Join Date: Mar 2019
Location: NJ
Posts: 1,534
|
Any chance you ran over a cat?
|
|
|
|
|
12-02-2020, 03:11 PM
|
#10 | |
|
Drives: 2017 Chevrolet Camaro ZL1 M6 Join Date: Jul 2020
Location: OR
Posts: 479
|
Quote:
|
|
|
|
|
|
12-03-2020, 01:42 PM
|
#11 | |||
|
Drives: Camaro ZL1 Join Date: May 2020
Location: Tampa
Posts: 166
|
Quote:
Quote:
These OEM pads will squeal as the pads wear down. I'd give the brakes a good hard stop from 20 or so and the noise should go away. For a while.[/QUOTE] Will give it a try. Quote:
|
|||
|
|
|
|
12-03-2020, 05:22 PM
|
#12 |
|
Account Suspended
Drives: '21 Wild Cherry ZL1 Join Date: Aug 2018
Location: WI
Posts: 2,082
|
That would suck.
Mine will do it occasionally when I first start driving it for a few stops then goes away. The TSB says to replace the rotors. https://www.tsbsearch.com/Chevrolet/18-NA-372 |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
