You are browsing camaro6 
12-28-2020, 10:41 AM
|
#1 |
 Drives: 2021 1SS 1LE Join Date: Nov 2015
Location: South Lyon,MI
Posts: 64
|
which race ramps for 1le
Which race ramps fit under a 1le? I did see the calculator on their site however I have my snow tires and wheels on so my ride height is a little taller right now, 245/45/19, so I can't get an accurate measurement. I was looking at the 67" xt and the 80" but would like to hear from people that have them. What did you go with and any regrets with the ones you picked?
|
|
|
|
12-28-2020, 11:52 AM
|
#2 |
  Drives: ISO ss 1le Join Date: May 2018
Location: FL
Posts: 764
|
The 56" fit by 1/4" under my 1LE. It was a bit close for comfort, so maybe go to the 67" route.
|
|
|
|
|
12-28-2020, 12:18 PM
|
#3 |
       
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 3,556
|
Looks to me that this jack would have far greater utility for racers https://www.quickjack.com/car-lifts/...EaAkJNEALw_wcB
__________________
'20 ZL1 1LE A10,
OEM short block, LME heads/valve train, E2650. 100+ octanes, no eth, no meth, no N2O. 2/23 - 1031/1004 wheel. 4/23 - 1.41/9.61/145 at DA 7000 ft. (only made five passes). 2/24 - LME 390, E2650, FBO, 100 oct.; 1116hp/ 1063tq; 109 oct. dyno next. |
|
|
|
|
12-29-2020, 12:25 AM
|
#4 |
|
Drives: 2019 Chevrolet Camaro SS 1LE Join Date: Nov 2016
Location: Arizona
Posts: 596
|
I recommend the two-piece 67" ramps.
|
|
|
|
|
12-29-2020, 10:52 AM
|
#5 |
Drives: 2023 CT5 Blackwing Join Date: Sep 2016
Location: Orlando
Posts: 1,617
|
I have a '17 SS 1LE. The Race Ramps RR-56 work just fine.
Ideally, get the QuickJack mentioned also. I have both. The ramps are the best for quick items like oil changes. The QuickJack for more involved things. It takes a while to get the QuickJacks into position and located properly.
__________________
2017 HBM SS 1LE
Sold 2023 Wave Metallic CT5-V Blackwing M6 |
|
|
|
|
12-29-2020, 04:37 PM
|
#6 | |
Drives: '18 1SS 1LE Join Date: Sep 2017
Location: Pennsyltucky
Posts: 2,571
|
Quote:
Store them under the car so when needed I just reach under and pull them out, throw the rubber blocks on the plates and lift the car right up. Drive in and out of the garage and don't know they're even there. Should mention the car has the bolt on ZL1addons lift blocks, makes lifting the car a snap.
__________________
'18 1SS 1LE Black, PDR
 |
|
|
|
|
|
12-29-2020, 05:57 PM
|
#7 |
|
Drives: 2021 1SS 1LE Join Date: Nov 2015
Location: South Lyon,MI
Posts: 64
|
At some point I’ll get quick jacks. Just not in the cards right now. Thanks for the input everyone. I ordered the 67” race ramps because of the width and height.
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
