[KARMAL]

Based on a chart I found (see below, I don’t remember where I found it), using launch control in Race Mode indicates “Drag Strip” launch control is active whereas in all other modes it indicates “Standard” launch control. I would think any time you’re using launch control it would be a drag strip situation. What is the difference between the two??

Vehicle is a 1SS 1LE with a 6 speed manual transmission.

[xplct]

I know you can adjust the amount of slip percentage and rpm launch in race mode, I dont know if it applies to the other ones, Ive only used it in race mode.

[KARMAL]

Originally Posted by xplct

I know you can adjust the amount of slip percentage and rpm launch in race mode, I dont know if it applies to the other ones, Ive only used it in race mode.

I believe you can only do that on the ZL1. I don’t see an option for that on the SS, unless I’m missing something? Or maybe that’s unique to the 2SS?

[SATINSTEEL1LE]

Best bet get a real DR on the back. And turn it all off. Then just stab it from idle. Or you can load up the converter a tad to keep the driveline snap lower to prevent something sheering off.

[xplct]

Originally Posted by KARMAL

I believe you can only do that on the ZL1. I don’t see an option for that on the SS, unless I’m missing something? Or maybe that’s unique to the 2SS?

Not sure if its unique to the 2ss or not, but its there. Ive used it a few times.