02-06-2021, 03:11 PM | #1 |
Drives: 2020 SS Camaro A10 Join Date: Jan 2019
Location: Columbus, Ohio
Posts: 120
|
ATI Underdrive Pulley
What tool is needed to hold the crank for removal and install of the balancer for a 10 speed automatic ?
|
02-07-2021, 07:00 PM | #2 |
Drives: 2018 Camaro 2SS Join Date: Jan 2021
Location: Louisiana
Posts: 10
|
Look online for a flywheel/flexplate holding tool (assuming you can’t find one local). There are many manufacturers that make them, they all work the same. Remove the starter, put the tool in place, bolt it down...remove the ridiculously tight balancer bolt.
__________________
2001 Z28 Full bolt on’s, ported 243’s, small cam, FMVB TH400 w/3,800 hard hit stall, 3.42’s. *sold* 😔
2018 SS Camaro A8 1LE replica wheels, bone stock otherwise 2008 F150 Daily driver 2002 Heritage Softail Classic 1.5 inch lower progressive rear springs/monotube fronts, 13" apes, 21" front mammoth spoked wheel, SE 10.5 cr heads, SE 264 cams, Mikuni HSR 42 flatslide carb, V&H pipes |
02-15-2021, 05:35 PM | #3 |
Drives: HBM ZLE Join Date: Aug 2017
Location: In the garage
Posts: 801
|
Anyone have recommendations on a tool to pull the balancer off? Getting ready to swap it on a zl1
|
|
|
Post Reply
|
|
|