[Viper-6]



[Mac7504]

Originally Posted by Smokin19

It's not that hard. Remove the plastic cowl first, then you will see all the nuts and bolts that need removed. You have to take the 10mm bolts and nuts off the cowl plenum #9. Then pry the plenum just enough on each end up enough to clear the center mount. The plenum has adhesive holding it in place. You need to just raise the ends enough to clear mounts.

Nice strut caps, where did you get those if you don't mind me asking.

A black set would look good as well.

[Smokin19]

Originally Posted by Mac7504

Nice strut caps, where did you get those if you don't mind me asking.

A black set would look good as well.

Phasetech

[hawk02]

Originally Posted by Mac7504

Nice strut caps, where did you get those if you don't mind me asking.

A black set would look good as well.

Too bad Rivercity Creations stopped doing all custom painting. They custom-painted my strut caps. They did outstanding work.

[willzilla]

Originally Posted by hawk02

Too bad Rivercity Creations stopped doing all custom painting. They custom-painted my strut caps. They did outstanding work.

Where did you get the caps? Only ones I see on phastek are ones with SS on them and only for the center piece.

[Mac7504]

Originally Posted by hawk02

Too bad Rivercity Creations stopped doing all custom painting. They custom-painted my strut caps. They did outstanding work.

Thast's super clean!

Originally Posted by willzilla

Where did you get the caps? Only ones I see on phastek are ones with SS on them and only for the center piece.

This, I do not see the bowties.