You are browsing camaro6 
10-16-2018, 07:16 AM
|
#1 |
      
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,787
|
Service suspension message after dyno session
I got a service suspension message after running my car on the dyno last weekend. My car is mrc equipped and everything seems normal except for the message. I'm hoping this will go away after a few key cycles. Has anyone else had a similar experience after a dyno session?
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
|
|
|
10-16-2018, 07:51 AM
|
#2 |
  Drives: 17 Camaro SS 1LE & 16 Sierra AT CC Join Date: Nov 2016
Location: Norman, OK
Posts: 2,424
|
Pull the battery and let the ECM reset. Some of those codes are caused from the front wheels not spinning, the other could be from the shop strapping the car down and the suspension not being able to move.
__________________
2019 Corvette Z06 2LZ A8 - Halltech CAI, AWE non-catted X-pipe, Mamo V2 ported TB 592rwhp, bone stock 566rwhp
2017 Camaro SS 1LE - Procharger D1SC w/ Tial 2" BOV & Race intercooler / ARH full length catless headers / Alky meth injection system - 650rwhp on conservative tune SOLD |
|
|
|
|
10-16-2018, 11:23 AM
|
#3 |
|
Drives: 2017 1SS/1LE Join Date: Sep 2016
Location: FL Panhandle
Posts: 1,559
|
I'm hoping the shop didn't strap it down by the rear control arms, and break the MRC sensor in the process... If it doesn't go away after a battery reconnect, visually inspect the sensors...
|
|
|
|
|
10-16-2018, 12:59 PM
|
#4 |
|
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,787
|
thanks for the input guys. I'm pretty sure the shop strapped the car down properly as they work on lots of Camaros. The mrc functionality is also definitely still there also. I'll reset the ecm and report back.
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
|
|
|
|
10-21-2018, 02:35 AM
|
#5 |
 Drives: 2016 Camaro 2SS M6 Join Date: Nov 2016
Location: Bay Area
Posts: 153
|
This happened to me a couple weeks ago right after my car got tuned on a dyno. Every time I started my car I’d get a pop up on the dash saying service suspension system. Somehow one of the rear MRC ride height sensors popped off and it was as simple as jacking up the car and removing the wheel and popping sensor back into place. If you lift the car high enough, removing the wheel probably isn’t necessary.
|
|
|
|
|
10-21-2018, 07:54 PM
|
#6 | |
|
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,787
|
Quote:
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
|
|
|
|
|
10-23-2018, 06:44 PM
|
#7 |
|
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,787
|
You nailed it, Est98ss except mine is worse. The passenger side rod is bent and the plastic rod end that attaches to the frame is gone! I'll bet that little s.o.b. will cost 30 bucks
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
|
|
|
|
10-25-2018, 01:48 PM
|
#8 |
|
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,787
|
Rod is not sold separately. Sensor part no. Is 23405177. 29.95 plus $3.45 shipping from thatgmpartsguy.
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
