01-26-2021, 10:37 AM | #1 |
Drives: 2016 camaro ss Join Date: Sep 2019
Location: florida
Posts: 4
|
high pressure fuel pump
i have a 2016 camaro ss. it has 16,000 miles on it. last october i had a high performance shop install an edelbrock super charger. 1500 miles later the high pressure fuel pump failed spilling gas into the engine. about 1500 miles after a new pump was installed the same thing happened. the installer doesn't seem to know why this is happening. anybody have a clue?
|
01-26-2021, 11:34 AM | #2 |
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,786
|
If you have an aftermarket cam, I'd say the pump isn't shimmed correctly. If you're on a stock cam, then I have no idea
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
01-26-2021, 02:39 PM | #3 |
Drives: 2022 Lt1 A10 Join Date: Nov 2015
Location: clark, mo
Posts: 8,860
|
Are you sure the pump failed or did one the fuel line pipes fail from the pump to the rails. Those are one time use only and should be replaced when you change the pump or injectors. The injectors also have seal and one of those could have leaked. Its also possible that as Jim said the pump wasn't shimmed correctly and caused the shaft to fail. I had a pump fail but it didn't cause any fuel to dump into the engine.
__________________
2022 Lt1 6.2 A10, Maggie 2300, THPSI Port Inj/10 rib, Rotofab, E, Nickey, SCOL, Griptech, RC Bandits, Hoosiers/MT 9.80@142.96 1.44 60ft, 6.34@112 707/669 RWHP/TRQ. 16SS Maggie 2650 9.41@147 1.35 60ft, 5.99@119. 16 C7 A8 10.90@128 Bolt on stuff
Last edited by laynlo15; 01-26-2021 at 02:55 PM. |
01-26-2021, 03:03 PM | #4 |
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,786
|
I'd think if it was his lines, it would have leaked immediately rather than after 1500 miles. I could be wrong though.
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
01-26-2021, 03:49 PM | #5 |
Drives: 2022 Lt1 A10 Join Date: Nov 2015
Location: clark, mo
Posts: 8,860
|
Its possible you are correct.
__________________
2022 Lt1 6.2 A10, Maggie 2300, THPSI Port Inj/10 rib, Rotofab, E, Nickey, SCOL, Griptech, RC Bandits, Hoosiers/MT 9.80@142.96 1.44 60ft, 6.34@112 707/669 RWHP/TRQ. 16SS Maggie 2650 9.41@147 1.35 60ft, 5.99@119. 16 C7 A8 10.90@128 Bolt on stuff
|
|
|
Post Reply
|
|
|