EBCM Connector Question - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

13 ZL1 · 11-22-2010, 04:06 PM

Does anyone know how to release the connector from the control module? There is a red tab that slides up but there appears to be more you have to do in order to release the connector. I did not want to try and force it.

13 ZL1 · 11-23-2010, 04:28 PM

I was able to undo it after taking a picture. The service manual says to make sure the ignition switch is off.

1. Pull back the Red tab to disengage from the gray plastic catch by the cable tie.
2. Push down on the ribs of the Gray plastic at the right edge of the Black plastic.
3. Pull back on the Black plastic which will eject the connector.

11-22-2010, 04:06 PM	#1
13 ZL1 Drives: 2013 IOM ZL1 Join Date: Nov 2009 Location: Manteca CA Posts: 683	EBCM Connector Question Does anyone know how to release the connector from the control module? There is a red tab that slides up but there appears to be more you have to do in order to release the connector. I did not want to try and force it.

11-23-2010, 04:28 PM	#2
13 ZL1 Drives: 2013 IOM ZL1 Join Date: Nov 2009 Location: Manteca CA Posts: 683	Figured it out I was able to undo it after taking a picture. The service manual says to make sure the ignition switch is off. 1. Pull back the Red tab to disengage from the gray plastic catch by the cable tie. 2. Push down on the ribs of the Gray plastic at the right edge of the Black plastic. 3. Pull back on the Black plastic which will eject the connector. Attached Images

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Please EXPLAIN Stabilitrak/Traction Control, Launch Control!	drtwo	Camaro Issues / Problems \| Warranty Discussions \| TSB and Recalls	10	01-26-2018 09:47 AM