You are browsing camaro6 
05-16-2022, 02:50 PM
|
#1 |
 Drives: Chevy Camaro Corvette Nova Blazer Join Date: May 2022
Location: Ohio
Posts: 5
|
ECU Pin for E85 installation
I have searched all over and cannot find a replacement ecu pin for the E85 sensor install. The kit I bought had the pink wire cut off.
|
|
|
|
05-16-2022, 03:04 PM
|
#2 |
     Drives: 2017 Camaro 2SS A8 Join Date: May 2019
Location: USA
Posts: 1,656
|
Is this what you’re looking to buy?
__________________
Roto-Fab w/sound tube delete, Katech ported TB, Pray IM, Velossa, DD side markers, DSX FF, UPR Catch can, Halo brace, My custom vent gauge pod
Originally Posted by arpad_m - “Aww, yet another oil thread with almost the same question in the OP“ |
|
|
|
|
05-16-2022, 07:49 PM
|
#3 |
|
Drives: Chevy Camaro Corvette Nova Blazer Join Date: May 2022
Location: Ohio
Posts: 5
|
Is that the correct pin that comes on an E 85 kit for a 2020 camaro? I have tried looking at pictures but can't tell. Other pictures it looks like it comes to a point at the tip?
|
|
|
|
|
05-16-2022, 08:18 PM
|
#4 |
|
Drives: 2017 Camaro 2SS A8 Join Date: May 2019
Location: USA
Posts: 1,656
|
I never had to replace this when I did my install. However, another member had an issue and this is what was used.
Here’s the thread. As mentioned in the thread, I’d also remove the butt connector, solder and add shrink tube. You could also reach out to 20Bluezl1 and get the yes or no answer. https://www.camaro6.com/forums/showthread.php?t=589879
__________________
Roto-Fab w/sound tube delete, Katech ported TB, Pray IM, Velossa, DD side markers, DSX FF, UPR Catch can, Halo brace, My custom vent gauge pod
Originally Posted by arpad_m - “Aww, yet another oil thread with almost the same question in the OP“ |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
