04-26-2018, 07:33 AM | #1 |
Drives: 2016 Camaro 2SS M6 Join Date: Nov 2016
Location: Bay Area
Posts: 153
|
How to wire 2 step to clutch?
I recently setup a 2 step/launch control which can be activated via 12v connection. I’d like to set it up to a clutch switch so that it’ll only go off when the clutch is fully depressed however I do not know which wire to tap into. Any ideas? At the top of the clutch I found these three wires.
|
04-26-2018, 07:47 AM | #2 |
Drives: 2017 ZL1 Vert - M6,SIM,CFW,NAV Join Date: Oct 2014
Location: United States
Posts: 496
|
This might be what you are looking for.
Top image is the B25B Clutch Pedal Position Sensor
__________________
***********************************************
2018 2SS Vert - Hot Wheels - Indy 500 #30 2017 ZL1 Vert - M6 , SIM, CFW, NAV 2017 RS 1LT 2.0T Vert - A8, Garnet Red - SOLD :-( Added - IO6 - NAV, UHS - Enhanced Display, K4C - Wireless Charger, UV6 - Heads-Up Display - DIY 2011 CTS-V - Black / Black - SOLD. :-( 2013 ZL1 - Black / Black - SOLD. :-( 2010 2SS - Indy 500 Pace Car. - SOLD. :-( 2002 Z28 - Pewter / Black - SOLD. :-( Last edited by Nitro66215; 04-26-2018 at 07:50 AM. Reason: Clarifying |
04-28-2018, 08:04 PM | #3 |
Drives: 2016 Camaro 2SS M6 Join Date: Nov 2016
Location: Bay Area
Posts: 153
|
Thanks for he diagrams, was able to get it done by tapping the yellow wire however the 2 step has to be switched off when starting the car or it won’t recognize that the clutch is pushed in, not sure if there’s another way around it.
|
09-11-2019, 07:55 AM | #4 |
Drives: 2017 Camaro 2SS Join Date: Jul 2018
Location: Miami, FL
Posts: 6
|
Did you have to cut the yellow wire to connect it or were you able to just tap it in the wire
|
|
|
Post Reply
|
|
|