[grampa_ss]

I'm at 28 cold. They heat up to about 30 and I get no warning lights. I'm actually going to try 26 next time out.

[KingLT1]

Originally Posted by Paintslinger16

What psi do you run when just cruising?

28-30 seems to be where they ride the best.

[KingLT1]

Did a couple 0-100's yesterday evening. Not bad for 30psi mid summer. I'm sure it will go into the 6's this fall with the tires lowerd to 26 psi.

[KingLT1]

Made a couple pulls last fall in cooler weather. Tires are pretty much too the wear bars. Pretty confident I can go mid 6's with a fresh set because I was spinning some on this 6.8 run.

[Kerry]

My best so far this is pisc stock setup with meth a10 2ss. toyos 315/30/20. I use launch control. Keeps it fro spinning so much from the stab. launch at 800. You can feel it kill power and see it kill timing in the log to stop the spinni ng and it does but as you get close to shift in first starts spinning again and of course it spins on the shift. Sometimes not too bad a few times pretty bad. On the street of course and the weather was cooler 58 i think da was about 200 ft. I got a set of the nto5rs drag 315 35 but they are just no better than the toyos. maybe if i smoked them real hard, never tried that just slight burn out. I would love to get a better hook. What do you think would a 345 help? They will fit but alas not as soft. I wonder if the 555rs might be better than the nto5r? Anyway good running car king. Always enjoy reading your post

[KingLT1]

Originally Posted by Kerry

My best so far this is pisc stock setup with meth a10 2ss. toyos 315/30/20. I use launch control. Keeps it fro spinning so much from the stab. launch at 800. You can feel it kill power and see it kill timing in the log to stop the spinni ng and it does but as you get close to shift in first starts spinning again and of course it spins on the shift. Sometimes not too bad a few times pretty bad. On the street of course and the weather was cooler 58 i think da was about 200 ft. I got a set of the nto5rs drag 315 35 but they are just no better than the toyos. maybe if i smoked them real hard, never tried that just slight burn out. I would love to get a better hook. What do you think would a 345 help? They will fit but alas not as soft. I wonder if the 555rs might be better than the nto5r? Anyway good running car king. Always enjoy reading your post

Nice run!!

I believe tire height and increased side wall becomes more important then width once you are up to a 305. You might be at a point where it's time to consider a 305/40/17 for more side wall. I know I am right on the cusp of needing to make the switch as well.

Thanks!

[grampa_ss]

Nice runs!
If you're not on a prepped track....us supercharged guys cannot stab it from a dig..not even on a DR. You gotta roll into it. I don't have a 0-100, but have a 0-103.56 @7.069 at around +1700DA

[Kerry]

Originally Posted by KingLT1

Nice run!!

I believe tire height and increased side wall becomes more important then width once you are up to a 305. You might be at a point where it's time to consider a 305/40/17 for more side wall. I know I am right on the cusp of needing to make the switch as well.

Thanks!

Yep thats for sure the next step. No more than I ever go to the track and for a daily I am haveing a hard time jumping that fence just to do a couple pulls and then take them off just to see what the car can do. ahh so addictive

[Flexhorn]

I tried MT 305/35/20’s and got Stabilitrak, ABS, wrench error message. I sent them back and have since rerouted the wiring harness. I may go with Toyo888R’s. If I use a 5mm spacer should the 315/30/20 work without rubbing?

[arpad_m]

Originally Posted by Flexhorn

I tried MT 305/35/20’s and got Stabilitrak, ABS, wrench error message. I sent them back and have since rerouted the wiring harness. I may go with Toyo888R’s. If I use a 5mm spacer should the 315/30/20 work without rubbing?

The Toyos work here on my MRC 2SS with a 3mm spacer, and there is a little room even without the spacer, but I wanted to be on the safe side. The ZL1 has a +43 offset 20x11 rear wheel, so it has the same size and offset specs as my aftermarket MRR wheel.

https://www.camaro6.com/forums/showt...6#post10740736

[Flexhorn]

Thank you very much for the info!

[QuarterMileSS]

Originally Posted by Joshinator99

I finally picked up a set of these tires for my stock wheels as well. They are beefy! They're as big as I'd dare go on these wheels. But so far they seem to be very solid. Looking forward to a good chance to get on it and test out some hopefully improved traction...!

Do they clear the inner wheelwells OK?

[Kerry]

I run the toyos 315 30 20 on 10.5 rim with 40 off set no problems but I did do the harness mod just to be safe

[Joshinator99]

Originally Posted by QuarterMileSS

Do they clear the inner wheelwells OK?

They do. I did move the drivers side harness as a precaution though.