You are browsing camaro6 
06-02-2020, 11:52 AM
|
#1 |
|
Used to own a ZL1
Drives: '16 Z06 Join Date: Apr 2020
Location: TX
Posts: 279
|
Dash rattle found! Now how to fix?
For the past 300 miles I've had a rattle somewhere on my dash. A bit upset because the car doesn't even have 1k miles! Well I finally found where it was.
On the gauge cluster there is the silver surrounding with a black piece above, and below. When I squeeze the silver piece from above and below with my fingers on the black pieces the rattle stops. See image below. https://imgur.com/kjxVZqZ Now then how can I go about fixing it? Squeeze some glue under there? Get a foam piece and stuff it in there? |
|
|
|
06-02-2020, 12:21 PM
|
#2 |
 
Drives: Black 2019 ZL1 M6, Join Date: Sep 2019
Location: Georgia
Posts: 322
|
see if you can find a dash disassembly diagram and depending on how it goes together tighten a few screws. but it its just regular push in clips maybe a few tooth picks pushed it. foam will probably need you to take the dash apart to do it correctly.
__________________
2019 Black ZL1, M6, CF Hood and Dash, Nav System, ZL1 Addons rock guards and lift points, Michelin Pilot Sport 4S, DD Smoked Marker Lights, Ceramic window tint, Gtechniq 9yr ceramic coating. JL Audio stealth box 12W6, Dyanamat trunk, Dead pedal cover, Soler TB/TC, Green Filter, Carbon-fiber Borla S-Type
|
|
|
|
|
06-02-2020, 01:09 PM
|
#3 |
  Drives: 2018 ZL-1 Join Date: Jan 2018
Location: Albuquerque
Posts: 947
|
Those silver pieces just pull out very easily. Pull them straight back towards yourself. Then you can at least have a look inside.
|
|
|
|
|
06-02-2020, 01:16 PM
|
#4 |
Drives: SEARCHING Join Date: Apr 2010
Location: Delaware
Posts: 411
|
GM really cheaped out on the dash material anyway....
|
|
|
|
|
06-02-2020, 04:38 PM
|
#5 |
|
Shifts under load
Drives: 2020 Camaro 1SS 1LE rally green Join Date: Apr 2017
Location: Fuquay-Varina, NC
Posts: 1,295
|
On my 17, it was coming from behind the radio screen. You pop off the plastic trim panel on the bottom edge and it exposes two little like 7mm bolts. I removed those, tilted the screen down and applied some foam strip behind the edges. Rattle gone!
__________________
24 Audi S3 prem plus, sport package
HPDE - southeast - JTI- solo, PCA- blue. 22 Suzuki GSX-S 1000GT blue |
|
|
|
|
06-03-2020, 09:33 AM
|
#6 |
Drives: 2022 ZL1(FEA suspension) Rapid Blue Join Date: Apr 2019
Location: Chemainus BC, Canada
Posts: 489
|
Is stuff like this covered under warranty?
|
|
|
|
|
06-03-2020, 01:15 PM
|
#7 | |
|
Craig
Drives: 2019 ZL1 1LE Join Date: Jan 2019
Location: Peterborough, ON Canada
Posts: 395
|
Quote:
__________________
 |
|
|
|
|
|
06-03-2020, 01:33 PM
|
#8 | |
         
Drives: 2017 Mosaic Bk ZL1 M6 Join Date: Jul 2009
Location: South of Raleigh, NC
Posts: 9,467
|
Quote:
__________________
 |
|
|
|
|
|
06-03-2020, 03:33 PM
|
#9 |
|
Drives: 2020 1SS 1le Join Date: Apr 2019
Location: SO CAL
Posts: 440
|
if its broken clips or loose from the factory the dealer should replace. If its barely anything take it out, use some 3m felt tape anywhere the materials make contact to each other then put it back in. Itll be gone.
|
|
|
|
|
|
|
|
|
Post Reply
|
| Thread Tools | |
|
|
