You are browsing camaro6 
07-04-2020, 01:21 PM
|
#1 |
 Drives: 2016 Camaro 2SS Join Date: Feb 2020
Location: Austin, TX
Posts: 70
|
IAT Breakout - Tuning tables?
Need schooled here. Wrapped up the IAT breakout install, and want to confirm what tables need updated. Looking at a 2013 CTSV, the IAT tables/resistance numbers and headers are different than the SS file.
1. Do the IAT and/or IAT2 tables need updated after the breakout. 2. What/Where do I find what the new tables need to be updated to? Seems like everyone is just installing these, but I only found one post that mentioned updating the tables from a CTSV file... however the tables dont match to copy/paste. Regards, Cody
__________________
16 Camaro 2SS - Turbo 7675CEA
85 Grand National - 03 Sierra - Prostreet TVS1900 |
|
|
|
08-18-2020, 02:06 PM
|
#2 |
|
Drives: 2016 Camaro 2SS Join Date: Feb 2020
Location: Austin, TX
Posts: 70
|
Just to close on this, i talked to Janetty, and he stated no modifications to tables are necessary. Just install breakout and plug in.
Car has been running fine. I did notice that the IAT's read a few degrees below ambient until warmed up. I also had P2199 code for IAT Sensor 1/2 Correlation code throw the other day randomly, but that should be unrelated.
__________________
16 Camaro 2SS - Turbo 7675CEA
85 Grand National - 03 Sierra - Prostreet TVS1900 |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
