02-22-2023, 10:18 PM | #29 |
D3RPZILLA
|
O yeah... I lift it up to just touching the zl1 lift pads and make sure the blocks are clearing the side skirts and fit nice in the pinch weld cut outs... lift a little more and look again... then lift to the first lock location... check all is sitting perfect.. then lift to the top and then drop it down on the 2 locks (checking again to make sure both are set). I then slide my race ramps 2 stack wheel cribs under all 4 tires for an extra layer of safety above and beyond lol.
__________________
2021 Camaro ZL1 Satin Steel w/a10/PDR/CF/Red Belts/Navigation
Website: z1lla.com | YouTube: youtube.d3rpzilla.com YouTube Playlists: Performance Mods | Interior & Exterior Mods | Other Mods |
03-10-2023, 11:49 AM | #30 | |
Owning SSes for 50 Years
|
Quote:
__________________
The new ride: 2023 Camaro, LT1, Sharkskin Grey
Previous Performance Cars: 1966 Chevelle SS 4M, 2010 Corvette 6M 1968 Dodge Charger R/T Auto 2012 1SS 6M 1982 Corvette Auto 2010 1SS 6A 1984 Corvette Auto 2016 2SS 8A 1999 Camaro Auto 2017 HBM 1SS 1le 2002 C5 Corvette 6M 2018 2SS 2006 Corvette Auto 2023 Camaro LT1 |
|
03-10-2023, 11:55 AM | #31 |
Shadow Gray '19 ZLE M6
|
I use race ramps wheel cribs too (more useful when the wheels are still on the car!), but I also toss a couple of jack stands under the quickjack itself for additional peace of mind.
__________________
2019 ZL1 1LE | M6 | SGM | PDR | CF Dash | Nav | Wheel Locks
PPF | Paint Correction | ZL1 Addons Rock Guards | ZL1 Addons Lift Pads | ZL1 Addons Feather Lite Tow Hook | JWM Smoked Sidemarkers | Wildhammer Smoked Rear Reflectors | JWM License Plate LEDs | RotoFab CAI | ADM IC Reservoir v2 | BC Forged RZ05 | SPL Toe Arms | BW Brake Deflectors | CMS Roll Bar | Schroth Profi II ASM Harnesses . Sold: '99 Trans Am (bolt-ons & cam) | '00 WS6 (bolt-ons, heads, cam, 12 bolt) | '05 CTS-V (bolt-ons, short throw) | '10 SS/RS M6 (short throw, CAI, coilovers, LTs, catback, JRE tune) | '01 WS6 YouTube |
03-18-2023, 12:56 PM | #32 |
Drives: 2020 LT1 convertible Join Date: Aug 2020
Location: Earth
Posts: 12
|
|
03-18-2023, 06:36 PM | #33 |
Shadow Gray '19 ZLE M6
|
If the QJ failed, it would fall onto the jack stands. That's why I positioned them there.
__________________
2019 ZL1 1LE | M6 | SGM | PDR | CF Dash | Nav | Wheel Locks
PPF | Paint Correction | ZL1 Addons Rock Guards | ZL1 Addons Lift Pads | ZL1 Addons Feather Lite Tow Hook | JWM Smoked Sidemarkers | Wildhammer Smoked Rear Reflectors | JWM License Plate LEDs | RotoFab CAI | ADM IC Reservoir v2 | BC Forged RZ05 | SPL Toe Arms | BW Brake Deflectors | CMS Roll Bar | Schroth Profi II ASM Harnesses . Sold: '99 Trans Am (bolt-ons & cam) | '00 WS6 (bolt-ons, heads, cam, 12 bolt) | '05 CTS-V (bolt-ons, short throw) | '10 SS/RS M6 (short throw, CAI, coilovers, LTs, catback, JRE tune) | '01 WS6 YouTube |
03-19-2023, 02:15 AM | #34 |
Drives: 2018 Camaro SS Join Date: Jan 2021
Location: Washington
Posts: 577
|
|
03-19-2023, 04:16 AM | #35 |
Drives: Chevy camaro Join Date: Jan 2022
Location: Tennessee
Posts: 192
|
Is the 5000TL long enough for my 2017 2LT Convertible? or do I need to order the 7000TL or the TLX model?
__________________
Glenn
2017 Camaro 2LT RS Convertible |
03-19-2023, 11:20 AM | #36 |
Drives: 2018 1SS 1LE Join Date: Jun 2018
Location: Union County, NC
Posts: 56
|
Unless the lift points are in a different place I believe it will work (but double check). I use the ZL1Addons lift pads and with the lift pads in the very front position at the front of the car, the 5000TL wasn't long enough even with the extensions. When I moved them to the lift point further to the back of the car, no extensions were needed and it worked just fine.
__________________
Current
2018 1SS / 1LE Previous 1967 w/ 327 & M21 1968 w/ 302 & M21 1968 RS/SS w/ 383 & M22 1986 IROC Z |
03-19-2023, 11:48 AM | #37 | |
Shadow Gray '19 ZLE M6
|
Quote:
I have heard of folks saying the TL (previous model was SLX) models work, but I would want to see pics for verification and to see where these folks are lifting their cars. I have the 5000EXT (which has been replaced by the TLX) and it BARELY reaches my ZL1Addons lift points. I would 100% go with the extended reach model.
__________________
2019 ZL1 1LE | M6 | SGM | PDR | CF Dash | Nav | Wheel Locks
PPF | Paint Correction | ZL1 Addons Rock Guards | ZL1 Addons Lift Pads | ZL1 Addons Feather Lite Tow Hook | JWM Smoked Sidemarkers | Wildhammer Smoked Rear Reflectors | JWM License Plate LEDs | RotoFab CAI | ADM IC Reservoir v2 | BC Forged RZ05 | SPL Toe Arms | BW Brake Deflectors | CMS Roll Bar | Schroth Profi II ASM Harnesses . Sold: '99 Trans Am (bolt-ons & cam) | '00 WS6 (bolt-ons, heads, cam, 12 bolt) | '05 CTS-V (bolt-ons, short throw) | '10 SS/RS M6 (short throw, CAI, coilovers, LTs, catback, JRE tune) | '01 WS6 YouTube |
|
03-19-2023, 01:21 PM | #38 |
Drives: 2013 Triple Black ZL1 Vert M6 ECF Join Date: Mar 2011
Location: Trenton, Michigan
Posts: 7,047
|
The Quickjack site has instructions on how and what to measure on your car to determine which model is a best fit for you.
IIRC this includes measuring the distance between the wheels along the rocker molding to make sure it will fit when you slide it under your car, and measuring the distance between the lift points. |
03-19-2023, 02:14 PM | #39 | |
Drives: 2020 LT1 convertible Join Date: Aug 2020
Location: Earth
Posts: 12
|
Quote:
|
|
03-19-2023, 05:21 PM | #40 | |
Shadow Gray '19 ZLE M6
|
Quote:
Would you mind taking pics of the locations you're lifting from on your '20 2SS? Same question to anyone else using an SLX or TL QJ model on our cars.
__________________
2019 ZL1 1LE | M6 | SGM | PDR | CF Dash | Nav | Wheel Locks
PPF | Paint Correction | ZL1 Addons Rock Guards | ZL1 Addons Lift Pads | ZL1 Addons Feather Lite Tow Hook | JWM Smoked Sidemarkers | Wildhammer Smoked Rear Reflectors | JWM License Plate LEDs | RotoFab CAI | ADM IC Reservoir v2 | BC Forged RZ05 | SPL Toe Arms | BW Brake Deflectors | CMS Roll Bar | Schroth Profi II ASM Harnesses . Sold: '99 Trans Am (bolt-ons & cam) | '00 WS6 (bolt-ons, heads, cam, 12 bolt) | '05 CTS-V (bolt-ons, short throw) | '10 SS/RS M6 (short throw, CAI, coilovers, LTs, catback, JRE tune) | '01 WS6 YouTube |
|
03-29-2023, 02:49 PM | #41 |
Drives: 2020 LT1 convertible Join Date: Aug 2020
Location: Earth
Posts: 12
|
Here is the 7000 TL and my 2020 2SS.
|
04-07-2023, 02:20 AM | #42 |
L8ap3x
|
5000 TL on my 18 2 SS. ZL1 add on lift pads also utilized.
Had my 5000TL for over a year now. Had the 2SS up half dozen times. 2 closest jacking points are indeed 60" or less.
__________________
"Manuals win hearts. Automatics win races."
2018 2SS 1LE HBM 6M |
|
|
Post Reply
|
|
|