[ZL1_IslandBreeze]

no rubbing but keeping a watch on it... great job... thanks Paul at PKAuto

20x10 w/20 offset 305/30/20 Goodyear F1s
20x11 w/38 offset 315/30/20 R888R

Paul at PKAuto explaining the offsets and tire setup: https://youtu.be/PNmV46MDo2c

[Torquem]

Offsets looks good!

[ZL1_IslandBreeze]

yes... Sorry about the video... i didn't take it... it is all Paul had.
BUT the center of the attention is the wheels... which i really like.
Car gets Eibachs next week...

thanks for viewing.

[cwebster]

Originally Posted by ZL1_IslandBreeze

no rubbing but keeping a watch on it... great job... thanks Paul at PKAuto

20x10 w/20 offset 305/30/20 Goodyear F1s
20x11 w/38 offset 315/30/20 R888R

Those wheels look great! I like the bigger meat on the front too. Glad to hear there's no rubbing issues with those offsets. I've got 345/35R18 MT ET S/S on BC Forged 18" rims with 43mm offset in the rear (Also from Paul at PK Auto) and they don't rub either. Rims have plenty of clearance around brakes and suspension but tires just barely fit in the wheel well - probably the largest I could go without rubbing something.

The motor sounds like she's begging to be throttled too. I'd like to hear that new exhaust note. Better yet, hear it roar past the stands at the track. Guess we'll have to wait for warmer weather for that, though, huh?

[cwebster]

Originally Posted by Torquem

Offsets looks good!

AhhHaHaHa! That video is hilarious! LMAO!!!

[Infern0]

Very yes.


Sent from my iPhone using Tapatalk

[Soleil]

Originally Posted by cwebster

?....I've got 345/35R18 MT ET S/S on BC Forged 18" rims with 43mm offset in the rear (Also from Paul at PK Auto) and they don't rub either. Rims have plenty of clearance around brakes and suspension but tires just barely fit in the wheel well - probably the largest I could go without rubbing something.

You really got 345 in the rear without rubbing.

[soceur77]

thats it, im flying out to rob you guys in Cali....buhahahaha good stuff bro!!! The lowering springs are really going to set it off!!!'

The vertical vid had me in tears!!!

[cwebster]

Originally Posted by Soleil

You really got 345 in the rear without rubbing.

Yup! I was a little worried at first so I put some duct tape on the inboard corners where I measured only about 1/4" clearance from the tread. Test runs showed that it never rubbed. I've had it at the drag strip dozens of times since without any rubbing at all. See this thread for details: Installed BC Forged Rims & MT DRs Post #5 shows the duct tape after test runs.

--Cal