08-05-2017, 12:13 AM | #1 |
What size pulley belt???
Anyone that's had a whipple put on. Can you tell me what length belt I would need if changing upper pulley only to 3.375 or 3.250? I have a 2016 2ss
|
|
08-05-2017, 05:37 AM | #2 |
|
Use the same belt, just move the adjusting bolt (driver side) to the outside
I'm running 3.125 pulley with original belt. (Whipple manual) 108. Using a breaker bar with 15mm socket, rotate the spring-loaded tensioner counter clockwise to its max open position. Route the supplied supercharger belt as shown in diagram. Use the "SLIDING IDLER" to remove all slack from the belt. Torque idler pulley to 22 ft-lbs and release tensioner. Tensioner must always be set at full to 3⁄4 open with a new belt. Failure to set this correctly may result in belt failure. ADJUSTABLE IDLER
__________________
2016 Camaro 1SS, Red Hot, K&N Blackhawk intake, Whipple Supercharger, 3.125 pulley, Kooks 2" long tube headers, High flow cats, secondary cats delete, Mishimoto catch can, P3gauge, Lots of dress-up crap that don't make it go any faster.
Car Journal http://www.camaro6.com/forums/showthread.php?t=490975 SC build http://www.camaro6.com/forums/showthread.php?t=492656 Drive, Ride, Fly It Like You Stole It GO BIG OR GO HOME Last edited by brettman; 08-05-2017 at 09:41 AM. |
08-05-2017, 08:44 PM | #3 | |
Quote:
|
||
|
|
Post Reply
|
Thread Tools | |
|
|