Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Engine | Drivetrain | Powertrain Technical Discussions > V8 LT1 Engine, Exhaust, and Bolt-Ons


Phastek Performance


Post Reply
 
Thread Tools
Old 01-12-2022, 09:42 PM   #1
Lonnie6.2
 
Drives: 2016 camaro ss
Join Date: Oct 2021
Location: Columbia sc
Posts: 7
Msd

Just installed my Msd intake and popped up with these codes
Attached Images
 
Lonnie6.2 is offline   Reply With Quote
Old 01-12-2022, 10:22 PM   #2
Kerry
 
Drives: 2019 2SS Camaro
Join Date: Apr 2012
Location: Tn
Posts: 450
Its cause u had things unpluged with out taking the battery loose. Just reset codes if u can or they will clear after a while as long as the car runs good. Or u can take battery cable off for a bit that should reset it
Kerry is offline   Reply With Quote
Old 01-13-2022, 05:23 AM   #3
Spaceme1117
 
Spaceme1117's Avatar
 
Drives: 2017 Camaro SS, 2011 Corvette GS
Join Date: Feb 2019
Location: Erlanger, Kentucky 41018
Posts: 588
Also, check bolt tightness and intake gaskets. You may have a vacuum leak.

First unplug the negative battery cable while you re-check everything. Leave it disconnected for at least 30 minutes.
Spaceme1117 is offline   Reply With Quote
Old 01-14-2022, 06:57 PM   #4
Ventmaster


 
Ventmaster's Avatar
 
Drives: 2017 1SS 6spd
Join Date: Jan 2011
Location: Utah
Posts: 2,534
It is imperative to go thru the staged tightening (1st pass, 2nd pass etc...) of your IM bolts in accurate inch/pounds increments with the MSD IM.
You must have a good in/lb torque wrench and don't forget to blue loctite the threads.
It is amazingly easy to over-tighten these bolts if you use your "time tested" dork wrench! do not go by feel!
If your codes don't clear after a power re-set, then start over and do it right or you will continue to have issues.
I really like my Tekton brand in/lb wrench. 1/4" drive with 10-150 inch pounds range https://www.amazon.com/TEKTON-TRQ211...11&sr=8-3&th=1
If you've already smashed the OE intake gaskets, replace them. And always- Have fun!

I've had my MSD with a 95mm TB in place for 2yrs now without a hiccup following this install. Enjoy!
Ventmaster is offline   Reply With Quote
 
Post Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:54 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.