[BlackbeastSS2]

Originally Posted by Joshinator99

Agreed, I’ve been running the Flatstoppers under my SS too for the past 2 winters. Works out perfect.

Gee I sure wonder what car dealerships do with cars staying on the lot for 6 months? I have never seen a square tire at a dealership in my life. Seems to be a waste of money IMO. But someone is getting rich off that idea.

[Joshinator99]

Originally Posted by BlackbeastSS2

Gee I sure wonder what car dealerships do with cars staying on the lot for 6 months? I have never seen a square tire at a dealership in my life. Seems to be a waste of money IMO. But someone is getting rich off that idea.

The techs do a burnout with your car to clean the tires up... my brother was a GM tech, he used to laugh about it all the time.

[Camaro_QC]

I've had my car stored for winter in my parking with the Camaro car cover twice since I got it. Never used anything under the tire and never got a flat spot.

Just make sure that your tires are inflated properly and you're done.

[Joshinator99]

Originally Posted by Camaro_QC

I've had my car stored for winter in my parking with the Camaro car cover twice since I got it. Never used anything under the tire and never got a flat spot.

Just make sure that your tires are inflated properly and you're done.

Your tires are not summer-only like SS/ZL1 tires are, so you have better odds of avoiding it than us. The softer the tire compound (and the stiffer the sidewall), the more likely you are to flat spot it. So high performance and high speed rated tires are much more likely to get it than all seasons or mileage oriented tires..

https://www.tirerack.com/tires/tiret....jsp?techid=42

[Camaro_QC]

Originally Posted by Joshinator99

Your tires are not summer-only like SS/ZL1 tires are, so you have better odds of avoiding it than us. The softer the tire compound (and the stiffer the sidewall), the more likely you are to flat spot it. So high performance and high speed rated tires are much more likely to get it than all seasons or mileage oriented tires..

https://www.tirerack.com/tires/tiret....jsp?techid=42

Didn't think about this. You should all get all season tires like the I4 RS haha!!

[Joshinator99]

Originally Posted by Camaro_QC

Didn't think about this. You should all get all season tires like the I4 RS haha!!

I’m sure those will hold up well with my Whipple’d SS... lol

[Scottyz]

What did I do today? Time to work on the no lift shift😈😈😈😈😈

[STYLO LT1]

Originally Posted by Scottyz

What did I do today? Time to work on the no lift shift����������

@scottyz I’ve always loved the look of that rear spoiler on the ZL1 1LE. Ya cars lookin great!

[DIYguy]

Installed LED reverse lights.
Specifically these-
https://www.amazon.com/LUYED-Lumens-...%2C201&sr=8-41
Along with load resistor harnesses-
https://www.amazon.com/HUIQIAODS-744...6111165&sr=8-1

They are extremely bright and pure white (unlike the dim yellowish originals).
The resistors mount where shown in the photo using #4 sheet metal screws with plenty of clearance.
I used a little heat sink grease between the resistors and the body for good measure.
I encountered a small problem with the harness connectors.
I had to trim the keying tabs on the sockets that plug into the tail light housings to get them to fit into the openings.
After a little work with a razor knife they insert and lock into place properly now.

[STYLO LT1]

Originally Posted by DIYguy

Installed LED reverse lights.
Specifically these-
https://www.amazon.com/LUYED-Lumens-...%2C201&sr=8-41
Along with load resistor harnesses-
https://www.amazon.com/HUIQIAODS-744...6111165&sr=8-1

They are extremely bright and pure white (unlike the dim yellowish originals).
The resistors mount where shown in the photo using #4 sheet metal screws with plenty of clearance.
I used a little heat sink grease between the resistors and the body for good measure.
I encountered a small problem with the harness connectors.
I had to trim the keying tabs on the sockets that plug into the tail light housings to get them to fit into the openings.
After a little work with a razor knife they insert and lock into place properly now.

Diyguy- Show us some before and after pics. I’d love to see them.

[Clearly_Canadian]

Installed my 1le replicas and drove down the river for photoshoot.

[DIYguy]

Originally Posted by STYLO LT1

Diyguy- Show us some before and after pics. I’d love to see them.

Sure, I will take one or two a bit later today if the weather cooperates.
I don't have a "before" photo exactly but maybe I'll put one of the old bulbs back in temporarily so you can see the difference between them.

[caSStro18]

Originally Posted by Clearly_Canadian

Installed my 1le replicas and drove down the river for photoshoot.

Those are the wheels I’d love to have! But, I can’t find them in a size that will accommodate my stock SS tires. So, either I get different rims, or I wait until I need new tires. That will take a LONG time because I only have 1,000 miles on my stock tires and I’ve had the car over a year now! But, love the look of those wheels! Good choice!

[arpad_m]

Originally Posted by caSStro18

Those are the wheels I’d love to have! But, I can’t find them in a size that will accommodate my stock SS tires. So, either I get different rims, or I wait until I need new tires. That will take a LONG time because I only have 1,000 miles on my stock tires and I’ve had the car over a year now! But, love the look of those wheels! Good choice!

Come on man, you gotta drive that car more You'll love wider wheels and tires, they allow even more aggressive cornering and of course look much better, too.