Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Technical Camaro Topics > Suspension | Brakes | Chassis


AWE Tuning


Post Reply
 
Thread Tools
Old 05-29-2020, 09:51 PM   #1
DNSS2
 
Drives: 2017 Camaro 2SS
Join Date: Jan 2020
Location: Washington
Posts: 22
Bilateral height uniformity after springs swap

I replaced my springs with BMR springs last week. I took it to alignment. Alignment went well. The rear was not even misaligned. Anyway, the left rear of my car now sits 1/8 inch lower than the right. Is that within accepted tolerance level? I got curious so I took the wheels off again and looked for any discrepancies between the two rear sides.

One side's spring is completely flushed with the lower mount. The other side is not completely flush. Pics below.



Then the lower mount is completely centered on the control arm on one side and on the other side it's on the left. Pics below.



Am I overthinking this? Is the difference negligible? I don't want to redo one side and then have to get alignment again.

Any feedback is appreciated. Thanks in advance.

Last edited by DNSS2; 05-29-2020 at 11:10 PM.
DNSS2 is offline   Reply With Quote
Post Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:38 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.