Computer dudes.. need help

franknbeans · 07-25-2011, 04:37 PM

I need a screen for my toshiba laptop. I watched a video on the install.. it is very simple.

What I am unsure of is where to get the screen

Toshiba Satellite L300
Part No. PSLB8U-0LQ04H
Serial # - 59367811Q

Any help would be much appreciated.

franknbeans · 07-25-2011, 04:39 PM

??

http://www.hootoo.com/154inch-toshib...FZBY7AodDEKeXA

christianmotox · 07-25-2011, 04:42 PM

Youre best bet is to call the manufacturer and get the part number from them. or take the screen off and look for the part number somewhere.

Good luck.

franknbeans · 07-25-2011, 05:10 PM

ok. i have the screen out.

IEC P/N: 6024B0033301
8

THE 6 COULD BE AN 8

christianmotox · 07-25-2011, 06:33 PM

does it have a barcode? on top of that pn?

jntarheels · 07-25-2011, 07:21 PM

from what i have looked at, either the one you posted (which is pretty inexpensive) or this one http://www.sparepartswarehouse.com/T...000133040.aspx should be fine

jntarheels · 07-25-2011, 07:23 PM

the 2 replacement P/N i found were:
V000100900 and V000133040

i didn't see anything about the number you gave us

jntarheels · 07-25-2011, 08:08 PM

here are the national parts depot numbers for you

franknbeans · 07-25-2011, 09:47 PM

Thanks for the info. I ordered the cheap one before looking back here. Is there a big difference ? Is the cheap one gonna be shit?

Most likely, that's why its cheap eh?

jntarheels · 07-25-2011, 10:26 PM

nah you should be fine, that replacement was the same resolution (1280x800) and size so it should fit just like the other ones, i just like to match p/n myself. i saw a good video on how to replace the screen, if you don't already have one.

franknbeans · 07-26-2011, 10:35 AM

yeah, i seen a video on you tube... very easy replacement. Pop out and stick new one in... only two connectors. thanks a lot for the help all.

franknbeans · 08-04-2011, 11:22 PM

go figure, I got the cheaper screen and for some reason it is barely bright enough to see..... BARELY see anything... It's going through a "system repair is checking your system for problems"

think the screen will get brighter when it's done?

*GTAHVIT* · 08-04-2011, 11:35 PM

Sometimes they may need to break in bit if you cam barely see it. It may be bad normally they brighten up a bit but not quite that much. Check the connection to be sure they are tight.

franknbeans · 08-08-2011, 10:31 AM

Hey jntarheels,

The part number on the back on my screen is V000120050 but when I plug my info into the website you gave me it gives me a different part number.

Toshiba Satellite L300 (PSLB8U-0LQ04H)

07-25-2011, 04:37 PM	#1
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	Computer dudes.. need help I need a screen for my toshiba laptop. I watched a video on the install.. it is very simple. What I am unsure of is where to get the screen Toshiba Satellite L300 Part No. PSLB8U-0LQ04H Serial # - 59367811Q Any help would be much appreciated. __________________ Car of the week 7/7/14

07-25-2011, 04:39 PM	#2
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	?? http://www.hootoo.com/154inch-toshib...FZBY7AodDEKeXA __________________ Car of the week 7/7/14

07-25-2011, 04:42 PM	#3
christianmotox Drives: ( . )( . ) Join Date: Feb 2010 Location: San Diego, CA Posts: 2,827	Youre best bet is to call the manufacturer and get the part number from them. or take the screen off and look for the part number somewhere. Good luck. __________________

07-25-2011, 05:10 PM	#4
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	ok. i have the screen out. IEC P/N: 6024B0033301 8 THE 6 COULD BE AN 8 __________________ Car of the week 7/7/14

07-25-2011, 06:33 PM	#5
christianmotox Drives: ( . )( . ) Join Date: Feb 2010 Location: San Diego, CA Posts: 2,827	does it have a barcode? on top of that pn? __________________

07-25-2011, 07:21 PM	#6
jntarheels Drives: Really Fast Join Date: Jun 2009 Location: Gallatin, TN Posts: 110	from what i have looked at, either the one you posted (which is pretty inexpensive) or this one http://www.sparepartswarehouse.com/T...000133040.aspx should be fine

07-25-2011, 07:23 PM	#7
jntarheels Drives: Really Fast Join Date: Jun 2009 Location: Gallatin, TN Posts: 110	the 2 replacement P/N i found were: V000100900 and V000133040 i didn't see anything about the number you gave us

07-25-2011, 08:08 PM	#8
jntarheels Drives: Really Fast Join Date: Jun 2009 Location: Gallatin, TN Posts: 110	here are the national parts depot numbers for you Attached Images

07-25-2011, 09:47 PM	#9
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	Thanks for the info. I ordered the cheap one before looking back here. Is there a big difference ? Is the cheap one gonna be shit? Most likely, that's why its cheap eh? __________________ Car of the week 7/7/14

07-25-2011, 10:26 PM	#10
jntarheels Drives: Really Fast Join Date: Jun 2009 Location: Gallatin, TN Posts: 110	nah you should be fine, that replacement was the same resolution (1280x800) and size so it should fit just like the other ones, i just like to match p/n myself. i saw a good video on how to replace the screen, if you don't already have one.

07-26-2011, 10:35 AM	#11
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	yeah, i seen a video on you tube... very easy replacement. Pop out and stick new one in... only two connectors. thanks a lot for the help all. __________________ Car of the week 7/7/14

08-04-2011, 11:22 PM	#12
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	go figure, I got the cheaper screen and for some reason it is barely bright enough to see..... BARELY see anything... It's going through a "system repair is checking your system for problems" think the screen will get brighter when it's done? __________________ Car of the week 7/7/14

08-04-2011, 11:35 PM	#13
GTAHVIT Blessed Drives: 2013 Sonic RS MT Join Date: Dec 2007 Location: Saint Augustine FL Posts: 28,444 View My Garage	Sometimes they may need to break in bit if you cam barely see it. It may be bad normally they brighten up a bit but not quite that much. Check the connection to be sure they are tight. __________________ Click image to see build thread. PQ - "the love of cars. It's a boys first step toward manhood and a mans last hold on boyhood." Fbodfather - "We do not want to use the Z28 moniker on a car that does not deserve this hallowed name." The_Blur - "Let's not confuse competitors with equals."

08-08-2011, 10:31 AM	#14
franknbeans Whipped Drives: 2010 CAMARO Join Date: Sep 2008 Location: Pittsburgh-ish - PA Posts: 4,216 View My Garage	Hey jntarheels, The part number on the back on my screen is V000120050 but when I plug my info into the website you gave me it gives me a different part number. Toshiba Satellite L300 (PSLB8U-0LQ04H) __________________ Car of the week 7/7/14

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fuse pull to reset computer	faninc	Camaro V6 LLT Engine, Exhaust, and Bolt-Ons	18	11-19-2010 06:36 AM
Need help from Computer dudes here. . .	franknbeans	Off-topic Discussions	86	09-14-2010 09:14 PM
Camaro Computer	GearHeadPeter	5th Gen Camaro SS LS LT General Discussions	2	09-10-2010 03:22 PM
OT - Need Computer Advice	Mblock66	Off-topic Discussions	29	08-20-2010 03:29 PM
Camaro Computer hacks?	2Muchmark	5th Gen Camaro SS LS LT General Discussions	17	02-06-2010 04:04 PM

User Name		Remember Me?
Password