[kdm123]

I'm looking to buy a second set of wheels for a ZL1-1LE. I would only want 19s, preferably in a width that would allow me to run a square set up so that I can rotate the tires. I don't want something super glittzy and expensive, just wheels that aren't any heavier than the stock ones.

[FNxR3DNECK]

I'd say a set of 19x11 square would be your best bet, Apex is a good go to, very good option at the price point they are.

Only issue would be you may need to use a pretty big spacer up front on a TRUE square setup.

the 19x10.5"s (22mm offset) would work too but you would lose some tire width, they should be able to be used on a ZLE without spacers. I run these with 305 RS4s but have to run a 5mm spacer up front because the MRC strut has less clearance than the DSSVs.

[Vtor_ZL1]

MRR M716 is nice setup - can easily accept 305 on both ends. Cheap and good enough.


You'll need spline drive thinner lugnuts as OE ones do not fit. Gorilla or similar.. like $30/set on amazon warehouse deals.

[kdm123]

Thanks for your response. I'll look into those.