[CH.CRAFT]

IT IS BEST TO USE DISTILLED WATER WITH SEVERAL DROPS OF DAWN DISHWASHING LIQUID PER QUART. THE DAWN HELPS TO BREAK THE SURFACE TENSION OF THE WATER WHICH ALLOWS THE WATER TO LAY ON THE SURFACE BETTER.

[KirkH]

Originally Posted by Camaro100

Ordered a set of fender hash marks from BigWorm Graphics. It would be a first time experience for me too

I ended up learning how to buy rolls of vinyl in bulk and make my own vinyl stripes and hash marks, using knifeless tape to cut the designs. It's easy, cheap and fun! I change up my vinyl stripes whenver I feel like it. I have had matte black, purple and currently, red.

With Avery and 3M vinyl I have never used any water . It is dry adhesion activated by pressure.

[KirkH]

This was about $15 in vinyl and about 30 minutes of time.

[Camaro100]

Great KirkH.

I got the delivery from BigWormGraphix this Monday. Went to professional body shop to get it installed but seems like passenger side hash mark got spoiled with two lines due to little bigger in size as professionals said. Driver side looks good after cutting a little from the bottom.

@BigWormGrahix,
If i have to order only Passenger side again, how much would it cost including shipping?

[bigwormgraphix]

Originally Posted by Camaro100

Great KirkH.

I got the delivery from BigWormGraphix this Monday. Went to professional body shop to get it installed but seems like passenger side hash mark got spoiled with two lines due to little bigger in size as professionals said. Driver side looks good after cutting a little from the bottom.

@BigWormGrahix,
If i have to order only Passenger side again, how much would it cost including shipping?

Sounds like they didn't look at the instructions, they are a little long so they can wrap around on the top edge. One side would be half price, email me at bigworm90@gmail.com and I can look up your order and get you a replacement.

[Camaro100]

Sure. Thanks.