[driftking123]

Originally Posted by DemonZL1

there is an idle procedure that you can do as well, just takes time. The tool is a shortcut, essentially, and not a requirement.

Thanks Demon, I'll look that up.

[driftking123]

Originally Posted by DemonZL1

there is an idle procedure that you can do as well, just takes time. The tool is a shortcut, essentially, and not a requirement.

Demon, why did you put the rear port on the corner instead of between the first section? Phastek and GPI both use the first section of the rows of lines. But in your video you are using the corner. Any preference or reason for it or does it matter? Oh I just thought of-does it make it easier to use the stock tubing?