04-13-2022, 10:33 PM | #1 |
Drives: 2018 ZL1 1LE and 1991 Z28 Join Date: Jan 2009
Location: SF Bay but from the 808
Posts: 1,078
|
Wheel Spacer/Wheel Stud Question
Hey everyone. I have a ZL1 1LE. I wanted to know if I ran a 3mm-5mm spacer up front, would I need to change out my wheel studs for longer ones? Or is the stock wheel studs still good and safe enough to use? Thanks in advance people!
__________________
In the garage: 2018 HBM ZL1 1LE // 2013 ZL1 (sold) // 1991 Camaro Z28 5.7L // 2016 Audi A6 Prestige Supercharged 3.0 V6 // 2002 Camaro SS (sold)
|
04-14-2022, 01:55 PM | #2 |
Drives: 2018 Camaro 2SS A8 Join Date: Jul 2017
Location: East Tennessee
Posts: 11,614
|
You're good up to 5mm, that'll give you a tiny bit more than minimum thread engagement, anything beyond that (say, a typical 8mm or more) I would definitely not risk.
Note that I only had a 5mm front, 3mm rear setup for the street and didn't track the car with spacers at all.
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle terminator cam | LT4 FS & injectors | TSP forged pistons & rods JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune 1100 - 1/30/18 | 2000 - 1/31/18 3000 - 2/06/18 TPW 2/26/18 3400 - 2/19/18 | 3800 - 2/26/18 4300 - 2/27/18 | 4B00 - 3/01/18 4200 - 3/05/18 | 4800 - 3/14/18 5000 - 3/16/18 | 6000 - 3/19/18 |
04-15-2022, 09:07 AM | #3 | |
Drives: 2018 ZL1 1LE and 1991 Z28 Join Date: Jan 2009
Location: SF Bay but from the 808
Posts: 1,078
|
Quote:
__________________
In the garage: 2018 HBM ZL1 1LE // 2013 ZL1 (sold) // 1991 Camaro Z28 5.7L // 2016 Audi A6 Prestige Supercharged 3.0 V6 // 2002 Camaro SS (sold)
|
|
|
|
Post Reply
|
|
|