04-07-2021, 09:32 PM | #1 |
Drives: 6th gen camaro ss Join Date: Oct 2018
Location: Colorado
Posts: 46
|
Ff sensor pin
What other pin can you use for the ecu connector side for the ff sensor other than pin 38 ?
|
04-08-2021, 08:27 PM | #2 |
Drives: 2021 LT1 10 speed auto Join Date: May 2013
Location: Connecticut
Posts: 2,343
|
|
04-09-2021, 12:43 PM | #3 |
Drives: 2021 1SS Camaro Join Date: Nov 2018
Location: Tulsa Oklahoma
Posts: 121
|
I see you have a 2021. Have you installed flex fuel on yours yet?
__________________
2021 Wild Cherry 1SS, LT2 Intake, Rotofab, Borla S-Type, Texas Speed longtubes, SMG flex fuel sensor, GPI Tuning, Bronze 1LE replicas
|
04-09-2021, 02:43 PM | #4 |
Drives: 2021 LT1 10 speed auto Join Date: May 2013
Location: Connecticut
Posts: 2,343
|
|
04-26-2021, 03:01 PM | #5 |
Drives: 6th gen camaro ss Join Date: Oct 2018
Location: Colorado
Posts: 46
|
|
04-26-2021, 04:58 PM | #6 |
Drives: 2018 Chevrolet Camaro 2SS 1LE 6M Join Date: Jul 2019
Location: California
Posts: 283
|
You can use RTV to hold the pin in the connector. Or you can replace the wiring harness. Option 'C' would be to obtain the connector from a wrecked car and wire it in.
__________________
Bolt-ons.
|
04-26-2021, 05:49 PM | #7 |
Drives: 2021 LT1 10 speed auto Join Date: May 2013
Location: Connecticut
Posts: 2,343
|
As long as the wire can be pushed into the hole and the clip stops it from being pulled back out, the blue lower base will hold everything in place and you push it all together and clip it.
|
04-26-2021, 06:20 PM | #8 |
Drives: 2021 LT1 10 speed auto Join Date: May 2013
Location: Connecticut
Posts: 2,343
|
|
|
|
Post Reply
|
|
|