[Evolvedx27]

no front plate on my car whatsoever!

[Canadian ZL1]

Originally Posted by gblaue

I only have 600 miles on my car, so far, but I find it seems less likely to hit going into parking lots than my Gen5 ZL1. I was thinking about welding on a little skid plate to add reinforcement to the mount. The motorized mount would be a waste of money. One good curb hit, and you'll scatter all the electronics all over the place. I'm not a fan of the plate being up, and to the left. I got a thing for symmetry. Bottom line, there is no good place for a front plate.

I totally agree that at the end of the day there really is no good place for the front plate on the ZL1. Unfortunately where I live (Ontario) without having a front plate I will just bring more attention to myself and the car.

I also agree that not having it in the center sucks BUT looking at the front a little closer it looks the 11 exchange coolers are below and so the plate regardless of it being on the left or in center will not effect air flow.

[gblaue]

Originally Posted by Mr. Wyndham

I haven't seen how it mounts....I just assumed there was drilling involved....if there is no drilling into bumpers and/or covers..., I may consider it.

The only holes that you have to drill are in the mount plate. You use the 2 most forward screws in the bumper/splitter. No drilling into the vehicle is required.

[Mr. Wyndham]

Originally Posted by gblaue

The only holes that you have to drill are in the mount plate. You use the 2 most forward screws in the bumper/splitter. No drilling into the vehicle is required.

Hate to be a pest....any pictures? Or instruction diagram?

I'm really interested because this would mark the first no-dril front plate holder by a manufacturer I've seen!

[Canadian ZL1]

Originally Posted by gblaue

The only holes that you have to drill are in the mount plate. You use the 2 most forward screws in the bumper/splitter. No drilling into the vehicle is required.

So just to be clear if you take the factory lic plate bracket option they do not drill into the front bumper? I haven't been able to find a picture as I don't know the placement and how high? Does it effect the airflow coming in?

I guess it comes down to preference on if you like it centered or off the left. Pick your poison gentlemen.

[gblaue]

Originally Posted by Canadian ZL1

So just to be clear if you take the factory lic plate bracket option they do not drill into the front bumper? I haven't been able to find a picture as I don't know the placement and how high? Does it effect the airflow coming in?

I guess it comes down to preference on if you like it centered or off the left. Pick your poison gentlemen.

I am not using a factory plate bracket. I do believe it is no drill. Here is a pic of a non-ZL1, but they are all the same, I believe.