06-01-2016, 07:02 AM | #15 |
Retired from Car mfrs....
Drives: 2LT RS/HR-V Join Date: May 2013
Location: /Fort Lauderdale
Posts: 10,048
|
Nice job but i think the car looks unbalanced with just front flaps, i'd do rear too. Just my opin.....I agree with the 3M tape, I use a lot of it....the real key is making sure both surfaces are absolutely virgin clean, before you stick it , especially on a flap.
|
06-01-2016, 08:38 AM | #16 |
Drives: 2016 Camaro 2SS Join Date: Nov 2015
Location: CT
Posts: 262
|
The area in front of the rear wheels of my 2010 Camaro had so many tiny chips it was unbelievable! I put molded mudflaps to the rear of the tires but I never imagined the front section would get torn up so bad? I installed the factory mudflaps on the 16 but am very concerned that the factory protection to the front of the rear tire wont be enough. I haven't even put my 1LE wheels on the car yet, kind of afraid too! I'm wondering why they didn't extend that protection all the way to the wheel well?
|
06-03-2016, 09:34 AM | #17 |
I can tell you that just mud flaps wont stop it. I had the mud flaps and still had issues. So I had the factory plastic removed and had a larger piece that covers up to the seam and a few inches under the door and I'm glad I did. There are some stops in the film now and I am probably going to have to replace it ever year or so. Better the xpel than my paint.
__________________
Adrenaline Red
20" 5 Spoke Black Black Side Spear Dual Mode Exhaust MRC Splash Guards 1G1FG1R74G0124089 |
|
06-03-2016, 02:09 PM | #18 | |
Drives: 2019 Camaro Zl1 Join Date: Apr 2016
Location: Buford, GA
Posts: 105
|
Just do the xpel and make sure it covers the areas you can already see being affected on the car.
Like I said I dont regret getting mine done, and I had mine done in 3M filmfor both sides at 160 dollars, and it further extends towards the front of the car, much further then the factory PPF which I think is a joke. Quote:
__________________
Letty 2016 2SS 6m Black (sold)
Sura 2016 Z06 3LZ 6m Black (sold) Talia 2019 ZL1 6m Black Bullets always have the right of way..... |
|
06-03-2016, 02:11 PM | #19 |
HYPER SS
Drives: 2016 Supercharged 2SS Join Date: Feb 2014
Location: Troy OH
Posts: 1,252
|
all good thoughts. Thanks all for your feedback.
__________________
Ordered: 1/15/2016
2000 status 02/01/16 3000 status 02/29/16 3400 status 03/07/16 TPW of 03/14/16 4200 status 03/17/16 in transit! Delivered 03/23/16 2SS Hyper Blue | 6M | NPP | Mag ride | ceramic white Int. | Black out bow ties | P3 Gauge| Front splitter. | 6 pot upgraded brembo brakes. | Magnuson Supercharger/95MM pulley | Rotofab Intake | ZL1 side skirts | HRE FF04 wheels - Michelin PSS4 | ZL1 add ons rock guards and lift points. | AWE touring - resinated catback with link pipes. |
06-03-2016, 07:34 PM | #20 |
Drives: '17 SS Join Date: May 2016
Location: USA
Posts: 40
|
Any one else mind sharing some input on how high the highest "Chip" is that they found on their rear fender?
Would hate to install film only to find a rock chip above where the film ends! I'm guessing the entire rocker panel might be sufficient since that piece goes up the front of the rear wheel pretty high but I'm not sure. Hell, has anyone gone all out and installed film to cover the entire rear fender? |
06-03-2016, 09:57 PM | #21 | |
Drives: '16 2SS Join Date: Nov 2009
Location: Orange County CA
Posts: 699
|
Quote:
__________________
My Intro Post | My Order | My Ordering Guide
TJCR2Q | 2SS Red Hot|Adrenaline Red|MX0 A8|56R Wheels|5ZU Blade Spoiler|NPP Exhaust|F55 MRC|IO6 Nav 4/06/16 1100 Ordered (waiting for 5ZU acceptance) 4/19/16 2000 Accepted with 5ZU 4/23/16 3000 TPW:5/16/16 5/06/16 3100 5/13/16 3400 Broadcast Sheet 5/24/16 3800 Vehicle Produced 5/25/16 4B00 Bayed 5/27/16 4300 Intermediate Delivery 7/9/16 Delivered! |
|
|
|
Post Reply
|
|
|