[ud03803]

I have been researching around about the different kits for our cars. But I figured I'd just ask the folks that I know have that info! I am looking for a simple kit, easy to install but looks good and doesn't break the bank. I won't be running it often, just now and then when that annoying kid in a Mustang won't leave me be. So I don't need all the extras like warmer, opener etc. My mods are in my sig but I think the relative info is I have an Atomic intake with ported TB. I looked at the MSD hardline plate kit and it looks really good, but I wonder if it will all mount properly with the stock sized TB.

I see several of the kits using a micro-switch for WOT activation. Instructions online are in short supply. Back in the day we'd install those on the TB somewhere to engage when the throttle cable pulled it WOT. But with ours - where does that go? Under the gas peddle? I haven't run nitrous since my 2000 SS and many things have changed. I appreciate any advice here.

[Paintslinger16]

So I have the NOS kit, and I actually haven’t finished installing, it comes with the mini 2 progressive. I think it’s going to be a solid kit in the end, Just be aware I had a few issues that Holley took care of, but still I had wait for them to ship out the shortages.

The main shortages was on the - an elbows and a TB gasket that is mentioned in the instructions but not in the parts listing.
If you look at the picture there is three red fuel elbows one of which goes into the fuel tap.
I only had two, so I call up and order it, they gave me a slight hard time because they said it only comes with the straight fitting shown in the tap.
Well the instructions say use the El, and it shows three, two on fuel solenoid one on tap, so in the end the replaced it.
So now it’s the next weekend so I have the parts. I thought anyway, when I get it apart again and now the instructions reference a TB gasket to be installed.
There was no gasket in the parts listing at all, so again on Monday I had to call them and get the gasket.

https://www.holley.com/products/nitr...parts/05159NOS

[ud03803]

Originally Posted by Paintslinger16

So I have the NOS kit, and I actually haven’t finished installing, it comes with the mini 2 progressive. I think it’s going to be a solid kit in the end, Just be aware I had a few issues that Holley took care of, but still I had wait for them to ship out the shortages.

The main shortages was on the - an elbows and a TB gasket that is mentioned in the instructions but not in the parts listing.
If you look at the picture there is three red fuel elbows one of which goes into the fuel tap.
I only had two, so I call up and order it, they gave me a slight hard time because they said it only comes with the straight fitting shown in the tap.
Well the instructions say use the El, and it shows three, two on fuel solenoid one on tap, so in the end the replaced it.
So now it’s the next weekend so I have the parts. I thought anyway, when I get it apart again and now the instructions reference a TB gasket to be installed.
There was no gasket in the parts listing at all, so again on Monday I had to call them and get the gasket.

https://www.holley.com/products/nitr...parts/05159NOS

Thanks for the feedback. I was also looking at the NOS kit because of the mini 2 stage. If I get it, I know what to look out for now!