[RedHotSS17]

I have a 2017 2SS with auto addict Velox tail lights. The brake lights work fine, NTR, DLR, Reverse also all work fine. Driver side blinker works fine. Passenger side blinker hyper flashes. I check all the connections, check the resistors with my multi meter, also replaced front blinkers. It's also not due to resistors overheating. Is there a way to tune it out or some intermediate wire that can fix it? And no, Blinker Fluid is not low, I topped that off too.

[KingLT1]

I am guessing it's a resistance issue. You might need to add another resistor or something if the stock taillights do not have the same issue.

[arpad_m]

You already did the bulk of the repair with the blinker fluid top-up, congrats

Silly jokes aside, it's likely what King said, the BCM induces hyper flash when it sees resistance values it deems too low. I would get a pair of smoked OEM tails, install those and never have this problem again, but it's just me.

[RedHotSS17]

I dont think it's the resistors, both sides are at 7.8Ohm and only the passenger has the issue. I was going to swap them but decided to see what happens if I run them while both resistors were unplugged, drivers side was still fine, passenger side was hyper flashing.