You are browsing camaro6 
01-31-2024, 03:47 PM
|
#15 |
          
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 4,192
|
I tapped the power lead to the CCM.
__________________
2020 ZL1LE A10.
LME LT4 390 short block, LME CID Heads, Kong E2650, FBO. 15" conversion, MT ET Street R 325/15. 100 octane: 1045hp/1055tq. 100 octane + Meth (1x10+): 1117 hp/1067 tq |
|
|
|
01-31-2024, 05:37 PM
|
#16 |
 
Drives: Camaro ZL1 Join Date: Apr 2023
Location: Albuquerque, NM
Posts: 24
|
I wired my Escort Redline 360C, with attached M2 dashcam using the blend mount. My mirror has the camera and I've never had an issue with it. I put a blend mount in my 2021 Trail Boss and hard wired it with a Gen5DIY kit so I can just move the detector and dashcam back and forth between vehicles. So far, I haven't had any problems with either vehicle.
|
|
|
|
|
01-31-2024, 07:08 PM
|
#17 |
Drives: 2020 Chevy Camaro ZL1 Join Date: Apr 2023
Location: Calgary Canada
Posts: 1,653
|
I have mine directly hard wired to my cigarette lighter type 12V power port on the console, and if I drive the shit out of the car, like Audubon type shit in middle of nowhere at 2 AM when I want to rely on it! it powers off? And that is the highest direct feed in cab amperage tap I could think of short of going to the battery
|
|
|
|
|
02-01-2024, 05:21 PM
|
#18 |
 Drives: 1987 IROC, 2020 ZL1 Join Date: Nov 2023
Location: Nashvile
Posts: 147
|
I've got the rearview mirror camera, and as shown wired directly into it. the mirror tap from blendmount was easy and the connector matches their install picture exactly.
have over 400 miles with this setup, and so far have not encountered any power cutouts, and it is a switch input that provides power when the car is started |
|
|
|
|
|
|
|
|
Post Reply
|
| Thread Tools | |
|
|
