You are browsing camaro6 
02-09-2021, 12:35 PM
|
#1 |
 
Drives: 2021 Wild Cherry 2SS Join Date: Oct 2018
Location: Pensacola, Florida
Posts: 50
|
2021 2SS Camaro Reverse light and license plate bulb sizes
Hey guys! I just bought a 2021 2SS and I want to switch out license plate and reverse halogen to LED. Any help would be appreciated!
|
|
|
|
02-09-2021, 01:31 PM
|
#2 |
      
Drives: 19 Chevrolet Camaro 2SS 1LE Shock Join Date: Apr 2020
Location: BC, Canada
Posts: 1,947
|
License plate bulbs are 194. I have the Sylvania LEDs on mine.
Reverse bulbs are 7440. I used the VLEDs bulbs. The license plate bulbs are plug and play, but the reverse bulbs need some modifications to work properly, or you will have a dim reverse light at all times and your reverse camera won't shut off. https://www.camaro6.com/forums/showt...php?p=10938832 Sent from toaster or something
__________________
Current:
2019 Chevrolet Camaro 2SS 1LE M6 Shock GM Performance Intake and that's it, because driver mods before car mods Past: 2009 Mazda RX-8 GT M6 Velocity Red Mica (Sold) 2015 Chevrolet Corvette Z51 2LT M7 Velocity Yellow Tintcoat (Flood totaled) |
|
|
|
|
02-09-2021, 01:54 PM
|
#3 | |
|
Drives: 2021 Wild Cherry 2SS Join Date: Oct 2018
Location: Pensacola, Florida
Posts: 50
|
Thank you!!
Quote:
|
|
|
|
|
|
02-09-2021, 02:24 PM
|
#4 |
 
|
I have personally swapped both on my 19 ZL1, I purchased the resistor harness by Gen 5 DIY for the 19+ reverse bulb swap. While it states on their website the bumper needs to be removed for this I found that to be false. If you are able to fit under the rear of the car you should be able to reach up from behind the diffuser into the bumper cavity and access the plug to the tail light assembly. It is absolutely a tight squeeze and almost impossible to see, making this a feel the way type of install. Once you unlatch the red safety clip its just depress the tab and unplug the harness. The install is simple as just placing the Gen 5 DIY harness right inline of the OEM setup. I would recommend placing zip ties to secure the slack if you go this route as there is a lot of wiring allowed to bounce around if not. The resistor on the bulb is a very simple solution and another great option that by all means cost less and is easier. I only choose the harness as I liked the idea of nothing sitting in the socket personally.
__________________
Morimoto Headlights, AWE Touring Catback, MM Catch Can, ADM V2 Reservoir, Roto-Fab, C&R Oil Cooler, 1LE Grills
|
|
|
|
|
|
|
|
|
Post Reply
|
| Thread Tools | |
|
|
