You are browsing camaro6 
02-25-2019, 06:43 PM
|
#1 |
 Drives: 2016 SS M6 Join Date: Mar 2018
Location: buffalo, ny
Posts: 13
|
285 front tires SS no MRC lowered car
First off I'm installing my RST Px1 springs soon and I'm going to upgrade my tires. Now since I don't have MRC, I'm going to drop a bit lower than a lot of other people I've seen here.. Now the question is will 285 30 20s PS4s fit and not rub at all even with the wheel cranked all the way to one side?
I was thinking about doing 275s if needed but 285 will look a bit better. I also have acs rock guards equipped if that'll make any real difference. |
|
|
|
02-25-2019, 08:54 PM
|
#2 |
      
Drives: 2016 2SS Convertible Join Date: May 2012
Location: St. Louis, MO
Posts: 1,780
|
What wheel specs?
|
|
|
|
|
02-25-2019, 10:13 PM
|
#3 |
|
Drives: 2016 SS M6 Join Date: Mar 2018
Location: buffalo, ny
Posts: 13
|
20x10.0 is +23mm (Front)
20x11.0 is +43mm (Rear) |
|
|
|
|
02-25-2019, 10:40 PM
|
#4 |
|
Drives: 2016 2SS Convertible Join Date: May 2012
Location: St. Louis, MO
Posts: 1,780
|
Seems like you will be OK. The wheel spec is nearly the same as the SS 1LE wheel and the PS4S tread is a bit narrower than the SS 1LE tire.
|
|
|
|
|
02-26-2019, 04:27 AM
|
#5 |
|
Drives: 2016 SS M6 Join Date: Mar 2018
Location: buffalo, ny
Posts: 13
|
Okay thanks, I hope it doesn't
 . I'm kinda worried about the rock guards but I can always take them off and swap to something like the zl1 add-ons rock guards that are super low profile... If that is the correct way to describe them.
|
|
|
|
|
02-26-2019, 01:52 PM
|
#6 |
      
Drives: 2016 1ss camaro Join Date: Feb 2016
Location: 909
Posts: 10,136
|
i have 20x10 in front but only did a 275/30/20 cause i was worried about that when i had the afe power springs
now i hae the yyz springs and am a bit higher so next time i buy new ones ill do 285
__________________
 16 1SS NIGHTFALL GRAY METALLIC WITH NPP #BECAUSERACECAR #SAVETHEMANUALS |
|
|
|
|
02-26-2019, 02:49 PM
|
#7 |
Drives: 2016 SS w/2SS A8 Blue Velvet Join Date: Dec 2009
Location: 39.793153,-86.238223
Posts: 3,678
|
I did the same, but with GM Performance springs and struts. Lowered 7/8th on all four corners and I'm running 285's up front and no rub. I was concerned but I was shown the geometry of the suspension in how the wheels don't go straight up but actually go up and inward from the top, so rubbing is a non issue.
__________________
Never grow up, it's a trap!
|
|
|
|
|
02-26-2019, 03:07 PM
|
#8 |
Drives: CAMARO Join Date: Jan 2017
Location: USA
Posts: 1,392
|
Here's my old setup - https://www.camaro6.com/forums/showthread.php?t=487398
Wheel Specs: MRR M017 Front: 20x10 +23 Rear: 20x11 +43 Tire Specs: BFG Comp 2 A/S 285/35/20 305/35/20 Car Specs: 2017 Camaro SS 6m/t Lowered on Eibach Spring 1SS Non-MRC You SHOULD add rock guards.. tires do stick out and will pick up a lot of rocks.. )   
|
|
|
|
|
02-27-2019, 02:58 AM
|
#9 |
|
Drives: 2016 SS M6 Join Date: Mar 2018
Location: buffalo, ny
Posts: 13
|
Nice ride man! Pretty similar to mine! Thanks for your input, the previous owner did use rock guards so that's pretty depressing for me. I put mine on right away, but the damage had already been done in just 1k miles :/. I'll go for the 285s then and see how it goes. Worse comes to worst I'll just swap them out to 275 if I ever have an issue
 .
|
|
|
|
|
02-27-2019, 05:51 AM
|
#10 |
|
Drives: 2016 SS w/2SS A8 Blue Velvet Join Date: Dec 2009
Location: 39.793153,-86.238223
Posts: 3,678
|
As stated the stone guards are a must and ZL1ADDONS have some damn good ones!
 Sent from my iPhone using Tapatalk
__________________
Never grow up, it's a trap!
|
|
|
|
|
|
|
|
|
Post Reply
|
| Thread Tools | |
|
|
