You are browsing camaro6 
10-02-2024, 03:51 PM
|
#1 |
 Drives: 2023 2SS 1LE Camaro Join Date: Aug 2023
Location: ON
Posts: 20
|
Borla Cat Back/ Tunnel Brace
I am going to be getting the Borla S Type cat back system for my 2023 SS Camaro but I cant seem to find out if I will need to get a HALO tunnel brace to replace the stock one. When I was looking at getting the speed engineering cat delete kit it mentioned that you need to replace the tunnel brace with one like the HALO.
Can anyone confirm if I need to do this or not for the Borla cat back? I'm pretty sure the Borla gets rid of the pinched off section of exhaust and I am not sure if It interferes with the stock brace or not. Thanks for the feedback. |
|
|
|
10-03-2024, 07:49 AM
|
#2 |
     
Drives: 2020 Chevy Camaro ZL1 Join Date: Apr 2023
Location: Calgary Canada
Posts: 1,652
|
I used all stock bracing on my ZL1.
|
|
|
|
|
10-03-2024, 12:17 PM
|
#3 |
 Drives: 2018 NFG ZL1-1LE Join Date: Jun 2018
Location: Near the water
Posts: 354
|
I used all the stock brackets as well on my ZL1 when I had a Borla setup. To confirm, go to Borla's website and you should be able to download a pdf of the installation instructions for the system. This should confirm if any modifications would be required.
|
|
|
|
|
10-05-2024, 11:00 AM
|
#4 |
|
old school chevy rodder
|
I have a Borla atak and use a BMR brace, some exhaust require shimming of the stock brace usually just with washers to make sure it does not rub and make noise....
__________________
2021 Wild Cherry ZL1 A10, Sunroof, Data,Red Carbon Interior, Nav, RotoFab Big Gulp , Elite x2ultra, Borla ATAK, Driveshaft shop, BMR susp, Speed covers, intercoolers, ATI , 2650 MAG, DSX lid, 103 NW, TSP Longtubes & cats, LPE, 1le mods, ,LME cover, Katech pump and chain, Trunnions, BTR stage 2, LPE boostapump, Gforce, Speed eng , Granetteli, etc etc
 |
|
|
|
|
10-05-2024, 12:17 PM
|
#5 |
 
Drives: 2017 Hyper Blue Camaro 2SS Join Date: Aug 2016
Location: Grayling Michigan
Posts: 94
|
Borla mid pipes are 2.75" I believe. Stock bracket should work as stated. 3" mid pipes require shimming or aftermarket brackets
__________________
 |
|
|
|
|
10-05-2024, 12:45 PM
|
#6 |
Drives: 2019 Chevrolet Camaro 2SS A10 Join Date: Jul 2019
Location: Hampton Va.
Posts: 534
|
I have a Stainless Works 3 inch exhaust and I had to use an aftermarket brace and shims as it would occasionally hit the brace going over railroad tracks.
__________________
2019 Camaro 2SS A10 Procharged, Flexfuel, with Stainless Works headers back to Legend series mufflers.
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
