10-25-2018, 12:34 AM | #1 |
Drives: 2014 camaro 1le Join Date: Jul 2018
Location: california
Posts: 4
|
is bumper removal needed to replace taillights?
got a 2014 ss, do i need to remove the bumper to change out my taillights? Is it only the 6th gen that does NOT need to remove the bumper?
changing it out for these bad boys tomorrow https://www.phastekperformance.com/H.../hero-5stl.htm |
10-25-2018, 01:20 AM | #2 |
INTSAGRAM: Failwish
Drives: 2019 /2SS LT1 Join Date: Jun 2015
Location: Tx
Posts: 232
|
That one second lag time...sweet
__________________
2019/LT1 2SS
|
10-25-2018, 01:27 AM | #3 |
Drives: 2014 camaro 1le Join Date: Jul 2018
Location: california
Posts: 4
|
|
10-25-2018, 01:27 AM | #4 |
INTSAGRAM: Failwish
Drives: 2019 /2SS LT1 Join Date: Jun 2015
Location: Tx
Posts: 232
|
__________________
2019/LT1 2SS
|
10-25-2018, 01:28 AM | #5 |
INTSAGRAM: Failwish
Drives: 2019 /2SS LT1 Join Date: Jun 2015
Location: Tx
Posts: 232
|
Im only kidding im getn them to..just waitn out the Thanksgiving rush
__________________
2019/LT1 2SS
|
10-25-2018, 05:26 AM | #6 |
Ret AF, cancer survivor
Drives: 2013 Camaro 2SS/RS & 2006 Corvette Join Date: Jul 2015
Location: Mesquite, NV
Posts: 2,741
|
Apparently, you do have to remove the bumper on the 2014 & 2015s to replace the tail light assemblies, at least based on every YouTube video I could find on doing so. I know you don't have to on the 2010-2013s, but that's little help to you.
__________________
|
10-25-2018, 07:03 AM | #7 |
Drives: '14 BRM 1LE 2SS/RS Join Date: Nov 2017
Location: Ft. Wayne, IN
Posts: 801
|
Yes you do. There is a plastic piece that attaches to the bottom of the lights that the bumper snaps onto (don't forget to transfer those to the new lights). You might be able to bend the bumper back far enough to get them out without removing it but a.) you will probably break something and b.) removing the bumper is pretty easy so you'll probably end up spending more time on it and it's guaranteed to be a bigger PITA if you don't remove it. My one word of advice is to be careful popping the clips around the marker lights, they break easy. Just pry that section back far enough to get a screwdriver in to pop the 2 clips on each side.
__________________
592 HP/590 TQ
LSA Blower w/ 2.45 Griptec, Reinforced Brick, FIC 1000 injectors, JRE FPCM, LFP Dual Pass HX, ZL1 IC pump, RotoFab CAI, Bo White TB, Coated Stainless Power 1-7/8" LTs, NPP, NGK TR7IX, Mighty Mouse Wild CC, AEM X-Series WB, Aeroforce Interceptor, MGW Shifter, Z28 Grill, Gary's Custom ZL1 Rockers, Hero Tails, Tuned by IMC |
|
|
|
|