You are browsing camaro6 
11-17-2017, 11:50 PM
|
#1 |
 
|
Weld wheel and tire size on lowered car?
Hey. My car is lowered on phastek 1.5” lowering springs. I was looking to get weld s71 17x10 and size 305 tire. I’m looking at Mickey Thompson et Street r tires
My question is would I be able to run this setup on a lowered car without a problem
__________________
|
|
|
|
11-19-2017, 05:24 AM
|
#2 |
 Drives: 2016 1SS D1SC Methfed Lowered Wrapd Join Date: Apr 2016
Location: CA
Posts: 632
|
wrong section but your backspace will be the deciding factor. that is about a 27 inch tire a bit less deflated to grip PSI....
You need a 6.43 backspace to run that setup without worrying about your car squatting and rubbing the rear quarter panels.
__________________
//2016 1SS M6 D1SC Upgraded IC 4.25 Pulley//
// Alky Control Meth Kit running 100% methanol // (purchased from JDP, installed by True Bliss Customs, tuned by NewEraPerformance in Augora Hills) // 3M/Gotch Design Sponsored Gloss Deep Space Colorshift Wrap // |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
