01-01-2024, 08:17 PM | #1 |
Drives: C7 Join Date: Jan 2023
Location: MN
Posts: 12
|
Ported LT1 Intake Manifold
*SOLD*
MN Metro $250 shipped Ported LT1 intake. Entrance opened up from 87mm to 93mm. It didn’t break through, but it was reinforced with plastic compatible 2-part epoxy to retain integrity at the snout where the material was thinned out. I used RTV sealant at the throttle body adapter instead of the o-ring seal since the 93mm inlet diameter left very little material for the seal groove. The intake runners were cleaned up and enlarged to match ported heads. 2.22” x 1.63” Many hours went into this manifold. I ran it 15,000 miles with zero issues. With 95mm Soler TB, ported exh manifolds, ported heads, AFE intake and E85 it put down 465/465 wheel hp/tq. 550/550 crank, STP correction, 4-5% less with SAE. Im selling because I’m moving to 103mm, MSD INTAKE, Headers, 6.8 stroker. Last edited by BMEP; 01-01-2024 at 10:42 PM. Reason: Sold |
Post Reply
|
|
|