[17camaroSS]

Originally Posted by s346k

at what point of milling do the intake manifolds run into fitment issues?

edit: also to clarify... youre running a cid head milled 60 with a 28 gasket? and a gigantor cam.

.060 is your limit before you start to run into fitment issue on the intake manifold.

Yea, .028 gasket and it’s a decent size cam. 27.5* overlap with some lift. But still smaller than the Track Attack cams from GPI, but so far it’s performed just as good as those at 3,640 pounds in 3k DA on the first WOT revision for tuning.