View Single Post
Old 01-05-2022, 11:01 AM   #7
The Maverick
Somewhere in the Kalahari
 
The Maverick's Avatar
 
Drives: 2021/18 (de-fresh) 3LT RS
Join Date: Dec 2017
Location: California
Posts: 639
Quote:
Originally Posted by Gunkk View Post
As stated by Vchula, because the plastic bits are not painted on the assembly line with the bodies with the same robots and same batch of paint, you will always see some kind of variation. Normally it's not too bad. But when it is, you get what you see in the OPs picture.
I wonder if there is any effort made on the assembly line to match up a fascia that is relatively close, and this is a "Friday car" situation for the OP, or if it is just luck of the draw on getting a fascia that blends better with the paint on the rest of the body? Perhaps something in the QC stage where they would swap in a replacement for something that appears to be this far off?
The Maverick is offline   Reply With Quote