|
I tore into the SS EPB module/cable puller and it has a speed drive controller for the electric stepping motor to pull the cable and release it. What appears to be a load sensing motor controller and a electronic cable tension circuit to monitor the tension on the cable.
So those other 9 wires tie into more of the car for monitoring and possibility other reasons. Again a wiring diagram would help.
I'd like to tear into a caliper EPB to see what it has too get an idea on it. But guessing how it is primarily in/out motor because of only 2 wires, its controller is else where in the car.
That might mean then defiantly no way to connect the 2, because of the 2 completely different ways they connect to the car and how they talk to the cars computer.
But that is about as far as i know at this point.
|