Sure,
After setting up my Solo2 DL via WiFi by selecting an ECU profile and defining a couple of display screens I took it out to the car. I started the car with the OBD2 adaptor plugged into the port but not into the Solo yet. With the car running at idle, I plugged in the OBD2 cable to the Solo and immediately got a warning that Traction Control was disabled following by a warning that StabiliTrak was disabled then a warning that the E-Dif was disabled, Etc. These are displayed on the Dash and accompanied by a warning chime.
I immediately unplugged the cable from the Solo, but the systems stayed disabled until I shut off the car and restarted it. After the restart everything worked fine with no warnings.
Just to test I plugged it in again and got exactly the same result. After reconfiguring the Solo to be "Silent on CAN" in RaceStudio I can now plug in in with not issues. At appears that the Solo disrupted communication in the CAN bus which causes systems attached to it to shut down.
Ren
|