[arpad_m]

Originally Posted by cheeze9878

I was wondering, I havea set of wheels with the fronts being 20X9 5X120 20 MM and the rears being 20X10.5 5X120 35 MM, can I fit 275/40/20 in the front and a 315/35/20 extreme contact on them or would I need to get a spacer and move the wire harness?

Only way to see if these exotic wheel/tire choices work is to try them.

I'd relocate the driver side main body harness in the rear and hope it's enough. The offsets look good, but these tires are a full inch taller than stock, the fronts will likely not clear the strut perch without a spacer either. The speedo will be off by quite a bit (4%), but the front vs rear ratio is almost OEM, so I don't expect codes or ABS/stabilitrak issues.

On a related note, I don't get the fascination with these higher aspect ratios, what do you expect of the taller sidewall? A significantly softer ride? Or is this about filling the wheel wells without suspension mods?