Quote:
Originally Posted by pzoom
Thanks!
No supports needed. I tried to make it super simple and easy to print. I went with quarter cubic 50% infill. I originally had 25%, but the piece that gets shoved between the console and carpet would break after several removal cycles. If you don't plan on pulling it out, you could go 25% and save a little print time.
I did it in ABS because I already had it loaded for another project. Probably would look nicer in PLA.  |
This is an awesome design Idea - I just need to stretch it to fit a Samsung Note 20 5G - will pass this on to a friend who has a 3D printer...much apoprecited!