Quote:
Originally Posted by BOYD3800SII
Suprised to see this thread resurrected! LOL! I got that from ZZPerformance. It was modeled for the 4 cylinder motor but it works with the V6 as well. It barely clears the engine cover by about 1/2 inch, and you will need to adjust it to make sure it does not rub the top of the cover. Also, the only thing I did was to add a washer to the end of each banjo bolt because I could not get any additional torque on it. Without the washer, the sway bar would not get tight enough for my liking. it works incredibly well and cheap too.
https://zzperformance.com/products/z...ut-tower-brace
|
Thanks! And yeah I see it made contact now. Was it hard to install the spacer TB ? I just got mine from airaid ... any tips will be appreciated it. I’m not very used to touch my car but losing the fear little by little. Just put on the K&N Typhoon and wow it sounds/ performs different.