[carguy55]

Originally Posted by kropscamaro16

lee replied back to me and told me this


The setup to install a Sparco QRT-R would be as follows.

- R-9170 Seat Track Adapter Driver Side
- R-9171 Seat Track Adapter Passenger Side
- R-9172 Sub Strap Mount (1 per side)
- Recaro Slider Part# 0.70.9NT (1 per side)
- R-9066 Side Mounts

The above setup will allow you to retain the 3-point seat belts while also using up to 6-point harness. The Seat Track Adapter also includes clip-in lap belt mounts.

That all looks good. What are you using for a harness bar or roll bar? The R-9066 side mounts look a little taller than the R-9061 he told me to use. I was not happy with the R-9061, they are too low and the bottom of the seat was hitting the mounting bolt. It would be nice if the mounting holes were slotted. You won't know for sure until you put it all together and see what adjustments you'll have to make. Just start first with making sure the Camaro track adapters fit and expect to take it in and out a lot and make a lot of adjustments.