I haven't found a replacement SS badge that I like for the bowtie location. I don't want the classic "bubble" logo because it doesn't seem to fit the SS model. And I don't think the angle works there either given the angled faces.
So I modeled one to be 3D printed and am looking for some feedback before I start printing it. I'll have to add a rear plate to match the factory bowtie front that uses the same fastener locations, but I need to remove the factory badge first. For now, I am focusing on the style. The size of this is 60mm by 170mm.
I think the face will be a color (for me, silver to match the rally stripes) and the rear (flats) would be black.
Modeled in Fusion360. Location and size of edge fillets is 5mm or 3mm, intentionally. Face fillet is 2mm, looks ok without the face fillet also.